Tips for Best Results

Operating theTransmitter(continued)

1.A “PRESET” selection in the menu allows you to reset all transmitter functions to their Restore Default Settings factory-default values.

2.Press the Set button once to move to Menu mode.

3.Press the Up arrow twice to move to “PRESET” in the LCD window.

4.Press the Set button once and “LOAD” will appear in the LCD.

5.Press and hold the Set button until “DEF” appears in the LCD.

6.Press and hold the Set button until “LOADED” appears briefly in the LCD. The window will then revert to “PRESET”.

7.Press the Down arrow once to move to “QUIT”.

8.Press the Set button once to exit the Menu mode and return to normal operation, with all factory- default settings restored.

1.Use only fresh alkaline batteries. Always replace all batteries. Do not use “general purpose” (carbon-zinc) batteries.

2.Position the receiver so that it has the fewest possible obstructions between it and the normal location of the transmitters. Line-of-sight is best.

3.The transmitters and the receiver should be as close together as conveniently possible, but no closer together than three feet.

4.The receiver antennas should be in the open and away from any metal.

5.Each transmitter-receiverpair must be set to the same frequency.

6. When using multiple systems, only one transmitter on a given frequency should be “on” at

a time.

7.If the “Out Level” of the receiver is set too high, it may over-drive the input of the camera/mixer or clip the output of the receiver, causing distortion. Conversely, if the receiver output is set too low, the overall signal-to-noise ratio of the system may be reduced.

8.You need to change channels 1) when a strong interference signal is received, 2) when the channel breaks down, or 3) during multiple-systemoperation in order to select an interference- free channel. Always turn the units off before changing frequencies.

9.Turn thereceiverandtransmitteroffwhennotin use.Removethebatteriesduringlong-termstorage.