9
Operating the Receiver
Overview… | Selecting Frequencies |
1.To turn the receiver on, press and hold the Power/Set button until the Power LED lights, and on your Receiver the LCD window comes on (about
window after the
2.Press the Power/Set button to enter the Frequency Selection Menu mode; the word “MENU” will appear in the upper left corner of the LCD window.
3.Use the Up/Down arrows to cycle through functions:
–first arrow up is Automatic Scan Group 1;
–second arrow up is Automatic Scan Group 2;
–third arrow up is Automatic Scan Group 3;
–fourth arrow up is Quit, allowing exit from Menu mode.
1.Press Power/Set button to enter Menu mode. The word “MENU” will appear in the upper Setting Receiver Frequency Manually left corner of the LCD window. The current frequency will be displayed in the LCD window.
Press Power/Set button and frequency will begin to flash and the word “EDIT” will appear above the frequency display; use up and down arrows to adjust the frequency. Frequency changes in 25k steps. To increase scroll speed, hold the up or down arrow for more than 4 seconds.
2.When you arrive at desired frequency, press and hold the Power/Set button until the word “STORED” appears. Frequency (which appears on the screen) is now set.
3.To “back out” of the Manual Frequency Set mode without making a frequency choice, simply press the Power/Set button once to exit the menu. The word “ESCAPE” will appear in the window, and no changes in frequency setting will be made; the receiver's audio output will again be enabled.
1.Press the Power/Set button to enter the Frequency Selection Menu mode; the word “Menu” will appear in the upper left corner of the LCD window.
2.Use the Up or Down arrow to reach Scan 1, Scan 2, or Scan 3. Press the Power/Set button once to select one of these three Scan groups. The word “SCAN1”,“SCAN2” or “SCAN3” will flash in the LCD window.
3.Press the Up or Down arrow to begin the scan. Press the Up arrow to scan up from the lowest frequency in the group; press the Down arrow to scan down from the highest frequency in the group
4.The first available frequency will flash in the LCD window. To activate this frequency selection, press and hold the Power/Set button until the word “STORED” appears in the LCD window.
5.If you do not wish to use the frequency found, you may press the Up or Down arrow.The Up arrowwith scan upwards,the Down arrowwill scan downwards,from the frequencyyou are on.
6.To “back out” without making a frequency choice, simply press the Power/Set button once to exit the menu.The word “ESCAPE” will appear in the window,and no changesin frequency setting will be made; the receiver's audio output will again be enabled.