Heath Zenith PF-4150-BK, PF-4150-SC Installation, Mode Switching Summary, As Shipped, Rotated

Mode Switching Summary

	TEST	ON-TIME Switch at 1, 5,
			or 10 minutes
	AUTO		Flip light switch
			off for one second
MANUAL MODE			then back on*

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.

INSTALLATION

Estimated Installation Time: 30 minutes Items needed for installation (not included):

•	Phillips and flathead screwdrivers
•	Pliers	• Wire strippers/cutters
•	Safety glasses	• Light bulb
•	Silicone caulk

For best performance, mount the fixture about 6 feet (1.8 m) above the ground.

WARNING: Turn power off at circuit breaker or fuse.

This fixture comes with a universal mounting bracket. It is pre-assembled on the fixture to fit the majority of junction box applications. However, if the slots on the mounting plate do not line up with the junction box screw holes:

1.Remove the fixture mounting screws from the mounting plate. Note: Do not remove the ground screw.

2.Attach ground wire “pigtail” to ground screw on mounting plate (See Recommended Grounding Method for additional information).

3.Flip the mounting plate over.

4.Rotate the mounting plate so the wire path is on the upper right. Note: The wire path on the mounting plate must be located as shown below to allow the wires on the back of the fixture to pass through.

5.Reinstall the fixture mounting screws and attach the mounting plate to the junction box as shown.

Wire Path		Wire Path
	Ground Screw

1.Remove two nuts.

2.Remove Mounting Plate.

3.Tighten screws finger tight.

Fixture Screws

Wire Path

Ground Screw

4.Attach mounting plate to junction box.

As Shipped	Flipped and
	Rotated

598-1165-05