Korg C-720 user manual Adjusting the effects, Setting the reverb effect

Editing sounds and performances > Adjusting the effects

Adjusting the effects

The C-720 is equipped with three types of effects:

Effect	Meaning
IFX (Insert Effect)	The sound pass entirely through this effect.
	This is used for effects being part of the
	sound itself, like the phaser of the rotary
	speaker. There is a separate IFX for each of
	the sounds.
Rev (Reverb)	This effect adds ambience to the sounds. In
	Layer or Split mode, there is a single reverb
	for all selected sounds.
Ch (Chorus)	This effect adds modulation to the sounds.
	In Layer or Split mode, there is a single cho-
	rus for all selected sounds.

The following diagram shows the effect’s routing:

￿￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿￿
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿￿￿￿￿￿
￿￿￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

Use the following parameters to select the reverb, chorus and insert effects, and adjust how much of the sound must be pro- cessed.

Setting the reverb effect

Reverb adds ambience to the sound. Either you are in Single, Layer or Split mode, a single reverb effect is available for both sounds (see diagram). A different amount of reverb can be ap- plied to each sound, thanks to the Reverb Send parameter (see below).

1.After having pressed the EDIT button, use the SCROLL button to go to the Reverb Type edit page, with the reverb type selected:

Reverb Type	3
Hall 1	On

Use the +/YES and -/NO buttons to select a different reverb. See below the list of available reverb effects (a more detailed list is on page 71).

Reverb

Hall 1	Hall 2	Hall 3
Wet Plate	Dry Plate
Room 1	Room 2	Bright Room

2. Press SCROLL again to select the Reverb On/Off pa- rameter:

Reverb Type	3
Hall 1	On

Use the +/YES and -/NO buttons to turn reverb on or off. This corresponds to the status of the REVERB indicator.

3. Press SCROLL to go to the Reverb Send edit page, with the M (Main) parameter selected:

Reverb Send 4

M:127 L:100

Use the +/YES and -/NO buttons to set the amount of reverb applied to the Main sound (0 ~ 127).

4. If you are in Layer or Split mode, press SCROLL again to select the L (Layer/Left) parameter:

Reverb Send 4

M:127 L:100

Use the +/YES and -/NO buttons to set the amount of reverb applied to the Layer/Left sound (0 ~ 127).

5.Press the EXIT button to return to the Main page and save the changes (see “Exit from the Sound edit mode” on

page 38), or the SCROLL button to go to the next edit page (see below).

41