Philips TTX400 manual Maxos TL-D extended trunking

Page 26

Maxos

Type

Suitable trunking and projectors

Length

Material

Installation

Main applications

4MX091

Projector adapter for Bus bar system

For trunkings with Bus bar system only, to fix specific projectors with ceiling base plate

600 mm

Sheet steel, white (WH) or silver (SI)

Click-in fixation (mechanical and electrical) on trunking. Most Philips projectors, versions with ceiling base plate - can be fixed by screwing the base plate to the projector adapter units

Retail (e.g. food, fashion)

Maxos TL-D extended trunking

The extended trunking sections are made of hot-dip galvanized steel with a white or silver finish.They are available in lengths of 1 and 2 electrical units of 58 W. Extensions of 300 and 600 mm in the middle only (M), or in the middle and at the end of these trunking sections (ME), allow interrupted lines where the gaps between the electrical units correspond to the extended trunking length.The gaps can be filled by blind covers, available as accessories.

A flat ribbon cable (5 wires) is integrated in the trunking and guarantees (in combination with an integrated phase selection switch and contact blocks) safe and correct cabling.

For suspended light-lines, the trunking sections are connected using the integrated electrical connector and a sturdy external mechanical coupling piece (accessory). Surface-mounted light-lines use the same integrated electrical connector and an internal coupler (accessory).

On the upper part of the trunking section, special knock-out openings enable cable entry wherever needed.

 

 

Maxos TL-D

 

 

Extended trunking

 

 

 

Type

 

4MX056

 

 

 

Length

 

1 x or 2 x length of electrical unit 58 W (581 or

 

582)

 

 

 

Electrical circuit option

 

Flat ribbon cable, 5 or 7 wires

 

 

Others on request

 

 

 

Extention length

 

300 and 600 mm in the middle (M), or in the

 

 

middle and at the end (ME)

 

 

 

Material

 

Hot-dip galvanized steel in white (WH) or silver

 

 

(SI)

 

 

 

Accessory

 

Trunking end piece and mains connection set

 

 

(9MX056 EP SET), trunking coupling pieces etc.

 

 

(see chapter Maxos accessories)

 

 

 

Light-line systems

Maxos 4MX091 projector adapter

Maxos 4MX056 TL-D extended trunking section M300/E300/M600/ E600 and blind cover, used to close the spaces in the trunking where no electrical units are mounted; available in white or silver

Philips indoor luminaires

Light-line systems

8.25

Image 26
Contents Page Light-line systems Selection guide Light-line systems Light-line systems Maxos Maxos the multifunctional performer, in proper style Main applications Retail4Public spaces IndustryOffices 4MX691 SDW-T Fast and smooth installation Resolutie te laag Maxos aluminum reflectors and optics Beam light distribution C-NB Wide-beam light distribution D-NB/DLine LightMaxos facetted reflectors and optics Beam light distribution F/F-WB/F-A systemsline Maxos trapeze reflectors and optics Emergency lighting, for TL-D onlyMaxos, 4MX092 TL-D asymmetrical trapeze reflector Maxos 4MX692 TL5 slotted trapeze reflector T-S-D/IMaxos 4MX092 TL-D perforated trapeze reflector Maxos TL-D Wing optic 4MX092 WG Wing opticLight-line systems Maxos electrical units Light-line systems Maxos standard trunking 7x1.5/7x2.5 for dimming 1-10 Separate emergency lightingMASTERColour CDM-T / G12 / 35 W Maxos projectors and HID solutionsSuitable trunking Trunking Decorative end-plates Retail e.g. food, fashionMaxos TL-D extended trunking Maxos 4MX056 TL-D IP64 trunking section Maxos TL-D IP64 trunking sections58 W Blind cover IP64, white Gasket between trunking sectionsHigh Frequency Performer HFP Maxos TL-D IP64 electrical unitsInductive Option Emergency lighting Hour EL1, 3 hours EL3Maxos TL-D IP63 closed reflector units Maxos Accessories Chain bracket, adjustable white or silverCoupling piece for trunking available in white or silver TTX400 TTX400 the value of lighting Experience of lightingLogistics Public areas TTX400 See new alternative with TMX400 C-2R onto TTX400 TL5 TL-DElectrical unit is mounted Reflector is mounted on the electrical unitLocation with the use of dedicated Pre-wired Linesense unit with integrated control functionMounting bracket for Movement detector LRM8117/00 Standard with a telejack splitter toTTX400 aluminum reflectors TL5 TL-D Light-line systems TTX400 multi-purpose reflectors Distribution MB systemsline Light GMX430 TL-D basic reflectors TTX400 TL-D basic reflectorsBasic reflectors Light-line systems TTX400 louvers and optics GMX555 TL5 multi-purpose reflectors and GGX555 white lamella TL-D TTX400 TL-D mirror inserts TTX400 electrical units TL5 TL-D TTX400 trunking sections TTX410 optional TTX400 units for projectors Electrical unit with an integratedTTX400 TTX400/410 suspension-/mounting brackets Suspension-/mounting bracketsMounting bracket for waterproof luminaire Mounting bracket for surface mounted luminaireZTX400 coupling piece for GMX430 TL-D basic reflectors With blind cover strips.To be used TTX400 Linesense Fully assembled TTX400 Linesense unitLight-line systems TTX150 Tetrix TTX150 a simple solution TTX150 2-lamp version onlyTTX150