Wired Mic and CD/Tape audio cuts in and | • | Reduce signal input if “Maximum | ||
out |
| Output” flickers |
| |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
Unit makes buzzing noise | • | Check cables – a damaged cable | ||
|
| will cause this. Unplug cables one | ||
|
| at a time until buzzing stops. | ||
| • Check for Ground loops | – use a | ||
|
| ground loop isolator where needed. | ||
Unit will operate only if plugged into AC | • | Check battery status LED |
| |
| • | Are batteries | charged? | If not, |
|
| check fuses and recharge overnight. | ||
Batteries will not hold charge | • | Replace Batteries every | ||
|
| unit is not left charging when not in | ||
|
| use. |
|
|
CD does not play | • | Is unit turned on? |
| |
| • Be sure CD or | |||
|
| tray correctly. Unit will not play | ||
|
|
| ||
| • Inspect disc for deep scratches or | |||
|
| cracks |
|
|
| • Check if player is in “pause” mode | |||
CD skips | • | Be sure unit is steady. | If it is | |
| • | jarred, this may occur. |
| |
| Check for scratches in CD. | |||
|
| Remove scratches with a CD | ||
|
| buffer/cleaner. |
|
|
Cassette Tape does not play | • | Is unit turned on? |
| |
| • Be sure Cassette is loaded in player | |||
| • Check if player is in “pause” mode | |||
| • Remove Cassette from player and | |||
|
| check for entanglement |
| |
Tape becomes entangled in cassette player | • | Carefully remove tape from player. | ||
|
| Clean heads and pinch roller with | ||
|
| rubbing alcohol and a swab or a | ||
|
| commercially | available | cassette |
|
| player cleaner. |
|
|
Specifications:
Rated Power Output: | 100 Watts peak/ 50 Watts per channel |
Max SPL : | 116 dB voice mode, 114 dB music mode |
Frequency Response: | 35 Hz – 20 kHz |
| (voice mode + 4 dB from |
Bass/Treble Controls: | 10 dB cut/boost @ 100 Hz, 8 kHz |
Unbalanced Input: | |
(Line Level) |
|
Balanced Input: | |
(Microphone Level) | Phantom Power 12VDC (switchable) |
Auxiliary Input: | Phono Jacks (right and left) for computer, MP3 player, etc. |
Sensitivity for rated output: |
|
Balanced Mic | |
Balanced Line | |
Unbalance Line | |
Line Output: | Buffered 600 ohm, 1 / 4 “ phone (pre fader) |
Speaker Output: | 1 / 4 “ phone jack (4 ohm impedance) |
Batteries: | (2) 12 Volt rechargeable SLA batteries, 7.5 Ah rated |
AC Power requirements: | |
Dimensions: | 24” x 16” x 14” |
Weight: | 54 Lbs. (With batteries installed) |
Warranty: | 6 years |
Serial #_________________________
AmpliVox Sounds Systems LLC 3149 Mac Arthur Blvd. Northbrook, IL 60062
13 | 14 |