There are three microphone input channels, (Channels 1, 2 & 3 on the Control Panel) and each channel has individual volume adjustment controls. See “Inputs and Outputs” section for more details.
PHANTOM POWER
If using Condenser type microphones, phantom power is required. To operate, insert microphone connector into Channel 1, 2 or 3 microphone input corresponding to the type of connector you have. Set the associated Channel’s INPUT SELECT button to the MIC position (it is in the Mic position when depressed), and press associated PHANTOM POWER to on. (Button is in ON mode when depressed).
VOICE/MUSIC:
This button is used to select voice or music. For speech, it provides a midrange boost for better sound projection when in the VOICE position. (Button is in VOICE position when depressed.)
OUTPUT MAXIMUM:
Red MAXIMUM OUTPUT LED light will illuminate when amplifier is clipping. This indicates a high amount of distortion is present. Adjust volume levels until LED no longer comes on while unit is playing music or voice is being amplified. Occasional flashing is acceptable.
CASSETTE PLAYER:
EJECT:
When this button is pressed, the door of the cassette compartment swings open to allow a tape to be inserted or removed. Close with a gentle push until a click is heard. The door cannot be opened during the playback or recording operation!
STOP:
This button will stop all tape transport functions such as play, record, fast forward and rewind. It will also disengage the
PLAY:
Press either the
REWIND:
The rewind function rewinds the tape from right to left and stops automatically once the beginning of the tape is reached. Press the STOP button on the Tape Player to manually stop Rewind.
FAST FORWARD:
The
RECORD:
Press the PLAY and RECORD buttons simultaneously to activate the Record mode. Recording will start instantly.
TAPE COUNTER:
Press this button to reset the tape counter to “0000”. The counter can be reset at any point while a tape is playing to mark a particular place on the tape.
PITCH:
The PITCH tuning control allows you to change the playback speed to alter the pitch of the sound. Turning the control clockwise will increase tape speed and counter clockwise will decrease tape speed. Normal position for this control should be at center detent.
NOTE: Channel 3 Volume Control controls Volume of Cassette Tape Player.
5 | 6 |