American DJ TP-DMX24F specifications Operating Instructions, Manual Mode, Chase Program

OPERATING INSTRUCTIONS Cont..

1. MAKE SURE THE TRANSFORMER IS CORRECT 16 TO 24 DC AND CORRECT POLARITY .

2.Plug in transformer and turn on unit. LED’s for HOLD / FLASH, TRAITS CHASE, PAGE 1 and DIMMER are on. you are now in MANUAL MODE

1. MANUAL MODE

Touch any (FIG 2.) CHANNEL 1-24BUTTON the LED will light and that channel is turned on, the maximum output is displayed on (FIG14.) LCD DIGITAL DISPLAY.

You can touch (FIG 3.) CH 1-24 HOLD/FLASH for 0.5 sec until LED for HOLD is lit. This will keep Channel LED’s lit until you touch them again.

2.PROGRAM

2.1CHASE PROGRAM

2.2ASSIGN SCENE PROGRAM

2.3DIMMER SETTING in MANUAL MODE

The CODE setting must be entered to enter PROGRAM MODE and to cancel the code of a Chase.

2A. Touch (FIG 6.) ASSIGN SCENE /BLIND and (FIG 9.) RECORD CHASE at the same time. for 0.5 sec.

LED’s will light for these and for HOLD on (FIG 3.) CH 1-24 HOLD/FLASH .

2B. Touch in sequence (FIG.1.) CHASE 8 , (FIG.1.) CHASE 9 , (FIG.1.) CHASE 6 , (FIG.1.) CHASE 2 , all LED’s will blink 3 times and LED’s on HOLD ASSIGN SCENE AND RECORD CHASE WILL REMAIN LIT. if correct code is entered. If a mistake was made the LED’s will turn off and you need to repeat step 2A.. and 2B.

The Memory capacity of this console is 24 Chases With each Chase containing 999 steps. 24 chan- nels are available for each step. The total steps available are 2304.

2.1 CHASE PROGRAM

MAKE SURE (FIG12 ) DIMMER FADER IS SET TO MAXIMUM WHEN STARTING TO PRO- GRAM.

A. Touch any (FIG.1.) CHASE 1-24(Using (FIG 4.) PAGE 1 / PAGE 2 ) Corresponding LED’s light and

(FIG14.) LCD DIGITAL DISPLAY read 01 indicating first step.

B. Touch (FIG 9.) RECORD CHASE for 0.5 sec. All LED’s will blink, you can then touch any (FIG 2.) CHANNEL 1-24buttons for 0.5 sec corresponding LED will light up. Touching any lit channel button again will cause it to blink rapidly. At this point you can adjust the dimmer level for that channel. any other channels in this step will remain at full value or what ever level you set them at. To change display from 0-100% to 00- 255 touch and hold for 0.5 sec (FIG 7.) AUDIO PERCENT TRAITS CHASE and move (FIG12 ) DIMMER FADER. Continue until all Channels that you need for this step are on.

TP-DMX24F™ Instructions page 4