Record / Chase, Assign Scene, Blackout

OPERATING INSTRUCTIONS Cont.

3. RECORD / CHASE cont.

There are 3 ways to control the chase program 1. CHASE, 2. AUDIO, 3. MANUAL

3.1. CHASE control

A. Set (FIG13.) CHASE FADER to SHOW position > 10 min.

The Chase will be controlled by what ever time was programmed in section 2.1 ( The default setting is 0.3 sec)

B. Set (FIG13.) CHASE FADER to any position up to 10 min

The Chase will be controlled by what ever time selected, all steps will be the same duration. C. Tap (FIG 5.) REAL TIME /TAP SYNC 2 times

The Interval between the 2 Taps controls the chase steps.

3.2. AUDIO control

A. Touch (FIG 7.) AUDIO PERCENT TRAITS CHASE AUDIO LED lights.

Chase is controlled by bass beats of Music. Sensitivity is adjusted by (FIG13.) CHASE FADER. If you have a line connected to EXT AUDIO input built in MIC is disabled.

3.3. MANUAL control

A. Touch (FIG 8.) MANUEL / STEP LED lights up and AUDIO and CHASE LED’s of (FIG 7.) AUDIO PERCENT TRAITS CHASE button turns off. Unit is in MANUAL control. Tap (FIG10.) SINGLE CHASE / MIX CHASE / STEP to step thru program.

4. ASSIGN SCENE

Once you have programmed TP-DMX24F and it is in MANUAL mode

A. Touch (FIG 6.) ASSIGN SCENE /BLIND for 0.5 sec. LED lights up indicating unit is in ASSIGN SCENE

B. When you want to assign Channel 2 to Channels 1-8 , touch (FIG 2.) CHANNEL 2, LED lights, (FIG14.) LCD DIGITAL DISPLAY reads 02,Channels 1-8 LED’s are on and their output is turned on. Touch (FIG 3.) CH 1-24 HOLD/FLASH until Hold LED is lit, then touch (FIG 2.) CHANNEL 2 , LED remains on as does Channel 1-8 LEDs.They remain on until (FIG 2.) CHANNEL 2 is touched again.

5.REAL TIME EDIT (USING (FIG 6.) ASSIGN SCENE /BLIND BUTTON)

5.1EDIT OUTPUT LEVEL while using CHASE MODE

Press (FIG 6.) ASSIGN SCENE /BLIND + touch the (FIG 2.) CHANNEL 1-24button of the CHANNEL, you wish to adjust, twice. The LED will blink rapidly use (FIG12 ) DIMMER FADER to change the value.

WHEN YOU EXIT FROM RECORD CHASE MODE EDIT IS CANCELED

4. BLACKOUT

BLACK OUT (no output) is engaged by touching (FIG11.) BLACK OUT LED blinks rapidly. To return to normal operation touch (FIG11.) BLACK OUT until LED turns off.

TP-DMX24F™ Instructions page 7