MASTER
49. MONO OUTPUT
At the monaural output the summed L/R master audio signal is present that can be used for additional monitoring, side fill and “next door” applications, or for the connection of a delay-line or subwoofer.
50. MONO OUT
With subwoofer operation, “next-door”, monitoring or delay line applications a pre/post-switch able mono output often comes in handy.
PRE-FADER: | The mono out’s signal is summed and outputted pre master |
| faders, i.e. the level at the mono out is independent from the |
| master faders’ settings. |
POST-FADER: | The mono out’s signal is summed and outputted post master |
| aders, i.e. the level at the mono out depends on the setting of |
| the master faders. |
Of course, controlling the SUB’s level via master fader makes sense when using an active monaural subwoofer. For monitoring applications, e.g. side fill on the stage, using the pre-fader setting seems more reasonable.
51. PHONES
Stereo phone jack for the connection of headphones with an impedance of
32 – 600 ohms. The audio signals of the channels with PFL buttons engaged is outputted via this connector.
The phones output presents the master L/R signal when there is no PFL button engaged.
52. PHONES
This control sets the volume of the headphones connected.
CAUTION: Make sure to set the control to its minimum position before connecting headphones
53. RECORD SEND L/R
These RCA-type connectors carry the PRE FADER master L/R signal. The signal is not affected by the setting of the master faders and therefore mostly used for the connection of cassette decks, open reel tape decks or DAT recorders for recording purposes. The nominal level of –10dBV of the outputs matches the professional industry standard as well as most home recording applications. Nevertheless, you should use the input gain control of your recording device - as far as it is provided. CAUTION: On most tape decks the input signal is directly carried through to the outputs. In case you have connected both, the REC. SENDS and the 2TRACK RETURNS, and the PowerMate’s 2TRACK to MASTER control is set to anything but its lowest setting, the recorded signal is included in the main mix again. The difference in delay of the two signals is responsible for dropouts and general degradation of the sound. In the worst case, activating the RECORD button on your tape deck could lead to very unpleasant feedback noise. To prevent this from happening make sure to set the 2TRACK to MASTER and the AUX3/4 controls to their lowest settings.
54. 2TRACK RETURN L/R
Here you can connect a tape deck, a CD player, an open reel or an additional SUB-mixer. The signal is post master fader and post STANDBY switch, which allows playing intermission music during performance breaks or checking the mix during the rehearsal, using the headphones. You just have to engage the STANDBY switch to mute all channel signals at the main outputs. The 2TRACK RETURN signal however will pass unobstructed.
