Cross Fader Section, 4C.F. Curve Control | Vestax PMC37Pro specification

CROSS FADER SECTION

C.F. MODE

!4C.F. CURVE CONTROL

Adjusts the crossfader curve. Counter-clockwise rotation gives a gentle crossfade, good for long running mixes. Clockwise rotation gives a steep crossfade, suitable for scratching and cutting.

	13	○
		1
		L
	CROSS FADER	E
	CROSS FADER	V
		V
		E
		L
	A	B
		POSITION

○

POSITION

○

POSITION

!3CROSS FADER	Rotate clockwise this volume, � 1 2	3
Mixes the signal assigned by C.F. ASSIGN SWITCH	C.F curve changes like a chart ( ○→ ○→○)
(!0) to A side of the crossfader and B side. When	fig-A CROSS FADER CURVE
the crossfader is set in the center position, both A	!5CUE LEVEL METER
and B can be heard. This is a detachable fader for	!5CUE LEVEL METER
ease of replacement with CF-37PCV when it is worn	The LED bar level meters indicate the signal level of
out. See "HOW TO CHANGE THE FADER UNIT".	PGM input selected by CUE SWITCH (!1).

MASTER-MONITOR SECTION

	LEVEL
		+8
15		+5
		+3
		+1
		+0
16		-1
		-3
		-5
		-7
		-7
		-10
		-15
17	CUE	L	R
17		POWER
	MASTER
18			BAL
18
	L		R
19			MASTER LEVEL
19
	MIN		MAX
			SUB MASTER LEVEL
20
	MIN		MAX

	MONITOR
21		MONITOR
	MASTERCUE	SELECT
	MASTERCUE
22	AUX1 AUX2
22	SPLIT	STEREO
	MONITOR LEVEL
23
	MIN	MAX

PHONES

!6MASTER OUT LEVEL METER

The LED bar level meters indicate the L and R outputs.

!7POWER INDICATOR

Lights up when the POWER SWITCH (#1) is on.

!8MASTER BALANCE VOLUME

Adjusts the signal balance of the L to R side of outputs from MASTER OUTPUT JACK (#9) on the rear panel.

!9MASTER LEVEL VOLUME

Adjusts the signal level outputs from MASTER OUTPUT JACK (#9) on the rear panel.

@0SUB-MASTER LEVEL VOLUME

Adjusts the signal level outputs from SUB-MASTER OUTPUT JACK ($0) on the rear panel.

@1MONITOR SELECT SWITCH

Used to select the cue monitor for PGM1～ 4 (selected by CUE position), MASTER out and effect receive (AUX 1 or AUX 2).

@2MONITOR STYLE SELECT SWITCH

When this switch is set to "SPLIT", the master signal is always heard through the right ear-cup of the headphones. The signal selected by MONITOR SELECT SWITCH (@1) will be heard in the left ear-cup. This enables both programs to be monitored simultaneously, thus assisting in beat mixing. When this switch is set to "STEREO", no master output is heard in the headphones, and only the signal selected by MONITOR SELECT SWITCH (@1) will be heard in both ear-cups.

@3MONITOR LEVEL VOLUME

Adjusts the monitor level through the headphones.

@4HEADPHONE JACK

Use this jack to connect the headphones. Headphones from 8ohm to 600ohm can be used.