SoundCraft 1601S manual Front Panel, EQ CUT -Rotary

Page 19

FRONT PANEL

1.CH1: 3 Position curve control and Reverse

These controls allow you to change the curve of the input fader and reverse the fader action. See also page 23.

2.X-FADER:Rotary position curve control and Reverse

These controls allow you to change the curve of the x-fader and reverse the fader action. See also page 27.

3.CH2: 3 Position curve control and Reverse

These controls allow you to change the curve of the input fader and reverse the fader action. See also page 23.

4.LEVEL -Rotary control

This control sets the audio level to the connected headphones. See also page 28.

5.HEADPHONE OUT -Jack connectors

Connect the 1/4” or mini jack plug from your headphones to the appropriate connector.

6.SELECT Toggle switch

This switch allows you to select MASTER or CUE monitoring. See also page 28.

7.EQ CUT -Rotary

This control can be used to change the CUE monitor EQ. To the right, high frequencies are cut and to the left, low frequencies are cut. See also page 28.

19

Image 19
Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow Headphones Safety Warning Safety Symbol GuideTIP Introduction Page General Precautions InstallationMains Installation Audio Wiring Initial Wiring ConsiderationsShielding Working Safely with Sound Points to RememberEnvironmental Considerations Inspection and InstallationPowering Unpacking and InspectionConnecting to a Typical Sound System Setting The Pre-trim Pads Making Adjustments and Fitting SparesPage TOP Panel 1601S Shown DescriptionPage Rear Connector Panel 1601S Shown EQ CUT -Rotary Front PanelMIC / Line Input Combi -XLR ConnectorOperation Getting StartedEQ -LOW Control Level ControlEQ -HIGH Control Clip Indicators Input Selector SwitchesPRE-TRIM Pads MID EQ Channel Volume FadersTrim HI EQSend -SELECT FX Send & Return / AUXSend -LEVEL Record OUTReturn / AUX -LEVEL Clip IndicatorFX ON/OFF Switch FX SEND/RETURN RE-CONFIGURATIONMaster / Booth Output Exciter FaderFader Curve Level Headphone MonitorMASTER/CUE Select Monitor Controls Sampler 1601S onlyLocking Onto the Beat Recording Loops Recording ModeSelecting the Sampling Source PLAYING-BACK Loops Play ModeShot Mode Reverse ModeRule of Thumb Loop Synchronisation AdjustmentsSampler Specification Disengaging the BPM EngineBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Post after the channel fader GlossaryEqualising the system to notch out the offending frequencies Riaa