SoundCraft 1601S manual Safety Symbol Guide, Headphones Safety Warning, Tip

Page 6

For your own safety and to avoid invalidation of the

warranty please read this section carefully.

SAFETY SYMBOL GUIDE

For your own safety and to avoid invalidation of the warranty all text marked with these symbols should be read carefully.

WARNINGS

The lightning flash with arrowhead symbol, is intended to alert the user to the presence of un- insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

CAUTIONS

The exclamation point within an equilateral triangle

is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

NOTES

Contain important information and useful tips on

the operation of your equipment.

HEADPHONES SAFETY WARNING

Contain important information and useful tips on

headphone outputs and monitoring levels.

Recommended Headphone Impedance >= 200 Ohms.

TIP

Contains a useful “tip” on how to get the best out

of your equipment.

6

Image 6
Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow Safety Symbol Guide Headphones Safety WarningTIP Introduction Page Installation General PrecautionsMains Installation Initial Wiring Considerations Audio WiringShielding Points to Remember Working Safely with SoundUnpacking and Inspection Inspection and InstallationPowering Environmental ConsiderationsConnecting to a Typical Sound System Making Adjustments and Fitting Spares Setting The Pre-trim PadsPage Description TOP Panel 1601S ShownPage Rear Connector Panel 1601S Shown Front Panel EQ CUT -RotaryGetting Started Combi -XLR ConnectorOperation MIC / Line InputLevel Control EQ -LOW ControlEQ -HIGH Control Input Selector Switches Clip IndicatorsPRE-TRIM Pads HI EQ Channel Volume FadersTrim MID EQRecord OUT FX Send & Return / AUXSend -LEVEL Send -SELECTFX SEND/RETURN RE-CONFIGURATION Clip IndicatorFX ON/OFF Switch Return / AUX -LEVELMaster / Booth Output Fader ExciterFader Curve Headphone Monitor LevelMASTER/CUE Select Monitor Sampler 1601S only ControlsLocking Onto the Beat Recording Mode Recording LoopsSelecting the Sampling Source Reverse Mode Play ModeShot Mode PLAYING-BACK LoopsDisengaging the BPM Engine Loop Synchronisation AdjustmentsSampler Specification Rule of ThumbBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Glossary Post after the channel faderEqualising the system to notch out the offending frequencies Riaa