Stereo Panel Descriptions and Functions

Stereo Panel Descriptions and Functions

L	L			L
R	R			R
A/V1	PHONO 1	A/V2	PHONO 2	A/V3	CD
A/V1	0	A/V2	0	A/V3

3. GAIN - This knob controls the input level from that

channels selected source. To increase the GAIN,

turn clockwise. Note: Adjusting this knob is not

synonymous to adjusting the channel fader. The gain

knob adjusts the input level from the source, while

the channel fader adjusts the output level from the

source.

PHONO 1

0	3	10		PHONO 2	0		10		CD	0
5	4	3	2	1	L	1	2	3	4	5
					L

4. CHANNEL FADER - The fader raises and lowers

the music volume of the channel as it is moved up or

down.

DIGITAL KEY CONTROLLER

7 #

5. CUE - This monitors the input signal from the mix

board to the headphones. Press CUE to hear that

channel through the headphones. Note: If you cue

more than one channel, those channels will be

A/V1

CUE

KEY

A/V2

CUE

KEY

A/V3

CUE

KEY

audible as well.

6. KEY - This assigns DIGITAL KEY CONTROL to

the channel. If the button is pressed, DIGITAL KEY

CONTROL will be applied to that channel.

7. DIGITAL KEY CONTROL – This Controller allows

you to modify the original key of a track without

changing its tempo. The Controller can step up or

down for a total of 11-Steps. To step DOWN, press

the left button marked “b”. To step UP, press the right

	CROSSFADER	9
ASSIGN	CROSSFADER	ASSIGN8

1.SOURCE INPUTS – These inputs are for connecting your MUSIC SOURCES to the KJ-7000 Pro. You can have both an A/V source and a turntable connected to each channel, however only one can be selected at a time via the source toggle switch (see below). Note: If you are connecting a turntable, be sure to connect it to the jacks labeled “phono”, as they have a lower signal output ratio and are designed specifically for turntables.

2.SOURCE TOGGLE – This switch will toggle between any sources connected to that channel. As stated above, if you have both a CD+G player and a turntable connected to the same channel, only that device to which this SOURCE TOGGLE is selected would be audible. Note: You can toggle sources “on the fly” at any time.

button marked “#”. To revert back to the ORIGINAL

key press the middle key. Note: Key changes are

only cueable when Master cueing.

8. ASSIGN – These buttons work in conjunction with

the crossfader slide control. ASSIGN allows the user

to select the channels to be included in the “cross

fade”.

9. CROSSFADER – The CROSSFADER allows the

user to fade the music out from one source and in to

another source creating a “mix”. Note: The

crossfader will only fade in/out from the two sources

that have been assigned to it.