AV-P2 Rear Panel
The rear panel of the AV-P2 Output Module contains the DC power connector, the left/right audio output Euroblock connections, and the A-Net connections.
The outputs on the AV-P2 use 5.0 mm Euroblock connectors, and can be connected to balanced or unbalanced audio devices. Male Euroblock jacks are provided.
AUDIO OUTPUT
18-24 VDC | RIGHT | AV-P2 | | |
| | LEFT | | OUT | IN |
The AV-P2 rear panel interface
Power Connector
The AV-P2 Output Module comes with an external DC switching-type power supply. This type of power supply can be used worldwide with a wide range of AC wall current output voltages (100-240VAC). When traveling, you do not need to replace the power supply in countries where voltages are different. You may, however, need plug adapters to allow the power supply to be connected to wall outlets in some countries, since many countries use different physical plug layouts for their power systems.
If a replacement power supply is required, always choose a power supply with equivalent specifications: 18-24 VDC, 500mA, center pin positive.
Audio Outputs
Audio outputs on the AV-P2 are provided via locking Euroblock connectors. Each channel’s output level can be set individually using the DIP switches on the front panel.
Euroblock connectors plug into the sockets on the AV-P2 panel.
The Euroblock plugs can be connected using only a small flat-blade screwdriver.
A-Net Connections
Two A-Net connections are provided on the rear panel of the AV-P2 Output Module. There is one A-Net In port and one A-Net Out port.
The A-Net In port receives digital data in Aviom’s proprietary A-Net format. The A-Net Out port is used to pass incoming A-Net data to additional A-Net compatible devices in a system. The A-Net Out port will always transmit the full 16-channel A-Net stream regardless of the settings on the AV-P2.
AV-P2 OUT IN
The AV-P2 rear-panel A-Net connections
