Aviom AV-P2 manual Setting Output Levels

Page 16

1.Strip the insulating jacket of the cable back about .75 inch (18 mm) to reveal the individual hot and ground wires within.

2.Remove a small amount of each individual wire’s insulation (approximately .25 inch, 6 mm).

3.On the Euroblock plug, use a small screw driver to loosen and open the sockets that will receive the individual wires.

4.Insert the audio cable’s hot (+) wire into the matching socket on the Euroblock plug.

5.Insert the audio cable’s cold (-) wire into the matching socket on the Euroblock plug.

6.Insert the audio cable’s ground wire into the matching socket on the Euroblock plug.

7.Tighten the screws on the wire sockets to secure the individual wires.

8.Plug the completed Euroblock plug into the desired output channel on the AV-P2.

9.At the other end of the cable, connect the hot (+) wire to the unbalanced device’s hot connector.

10.Connect the cold (-) and ground wire to the unbalanced device’s ground connector.

11.Connect the completed cable to your audio device.

Plug the completed Euroblock connectors into the AV-P2 audio output jacks.

Setting Output Levels

Output levels on the AV-P2 are set with the DIP switches on the front panel. Individual settings are possible for the left and right audio channels.

LEFT RIGHT MUTE

ON

OUTPUT LEVELS

The AV-P2 front panel interface

To temporarily mute the output of the AV-P2 while adjustments are being made, move the Mute switch to the left.

16

17

Page 15 Page 17
Image 16
Page 15 Page 17
Contents AV-P2 Certifications TrademarksImportant Safety Instructions Warranty Information Aviom, Inc. Limited WarrantyTable of Contents Page Package Contents WelcomeFront Panel Components Rear Panel ComponentsCompatibility Pro16 Series Systems About A-NetCat-5e Cable Lengths Cables Used With A-Net DevicesSystem Bridge Cleaning and Maintenance AC Line ConditioningMounting the AV-P2 Extending Cable LengthsPanel Descriptions AV-P2 Front PanelPower Connector AV-P2 Rear PanelAudio Outputs Net ConnectionsConnecting Audio Wiring a EuroblockConnecting to a Balanced Device Connecting to an Unbalanced DeviceSetting Output Levels DIP Switch Settings Table DIP Switch SettingUsing an A-Net Distributor Net ConnectionsSeries Connection of A-Net Devices Parallel A-Net RoutingAudio Networks Channel SystemsExtending A-Net Cable Runs Digital SplitsTo headphones Net ExpansionChannel Examples To configure a 32 x 0 systemChannels Send by Zero Channels Return Adding More Audio Outputs To configure a 16 x 16 systemChannels Send by 16 Channels Return Expanding a Network with an A-Net Distributor To create an expanded networkSpecifications DimensionsBlock Diagram Aviom Warranty Registration Fax this form to Aviom at +1Index Specifications  Split 
Top Page Image Contents