Bosch Appliances PLE-1MA060-EU, PLE-1MA030-EU, PLE-1MA120-EU manual Rear panel

Page 10

Plena Mixer Amplifier Installation and User Instructions Description

en 10

2.4.3Rear panel

See figure 2.3 for an overview of the connectors and switches:

1 Tel. emergency/100V input, Euro style pluggable screw terminal connector - VOX function. This input has highest priority.

2 Telephone emergency/100V input volume control - control range -25 dB to 0dB (see number 1).

3Remote control wall-panel-input, RJ-45 connector. Wall panel incorporates: BGM source selection, and

zone on/off control.

4Ducking level control for microphone/line inputs 1 and 2.

5Music input (number 1 disc), 2x RCA/cinch connectors. Stereo, summed mono.

6 Music input (number 2 radio), 2x RCA/cinch connectors. Stereo, summed mono.

7 Music input (number 3 auxiliary), 2x RCA/cinch connectors. Stereo, summed mono.

8Music master output, XLR connector - switch setting for line out, or music only. This output can carry out either music only, or the master output. For more

information, see chapter 4.2.3.

9 Cooling fan (PLE-1MA120 only).

Note

Always allow adequate space at the rear of the

unit for ventilation.

10Microphone/line 1 input with trigger, Euro style pluggable screw terminal connector - DIP switch settings for: chime, PTT (push to talk), mic/line, speech filter, and phantom power (see number 12). Input is wired in parallel with microphone/line 1, XLR connector (see number 11).

11Microphone/line 1 input, XLR connector - DIP switch settings for: chime, PTT (push to talk), mic/ line, speech filter, and phantom power (see number 12). Input is wired in parallel with microphone/ line 1, Euro style pluggable screw terminal connector (see number 10).

12DIP switch for microphone/line 1 and microphone/ line 2 (see numbers 10 and 11, and 13 respectively).

13Microphone/line 2 input, XLR connector - DIP switch settings for speech filter, mic/line, VOX, and phantom power (see number 12).

14Microphone/line 3 input, XLR connector - DIP switch settings for mic/line, and phantom power (see number 15).

15DIP switch for microphone/line 3 and microphone/ line 4 (see numbers 14 and 16 respectively).

16Microphone/line 4 input, XLR connector - DIP switch settings for mic/line, and phantom power (see number 15).

17Outputs:

•Call only, screw terminal connector 100 V.

•Screw terminal connector 100 V, and 8 Ohm.

18 Mains fuse.

19 Earth connection screw.

Note

The unit must be earthed.

20 Mains connector (3-pole).

Bosch Security Systems 2007-11 PLE-1MA030-EU, PLE-1MA060-EU, PLE-1MA120-EU en

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Plena Mixer Amplifier Important safeguards Table of contents Operation Digital document Intended audience IntroductionPurpose Related documentationConversion tables Conversion of units of massPlena product range Contents of boxDescription Plena Mixer AmplifierSchematic overview of the Plena Mixer Amplifier Front panel Controls, connectors and indicatorsPlena PLE-WP2Z3S wall panel Rear panel Rear panel Intentionally left blank Check settings/connections InstallationInstall unit in rack optional Unpack unitIntentionally left blank Connecting inputs Connections and settingsPriority microphone input Secondary microphone input Additional microphones inputs 3Connecting 100 Volt input signal Emergency inputsConnecting emergency telephone lines Connecting music source inputs Music source inputsCall only Connecting outputsMain output Master outputConnecting speakers Constant voltage loudspeakersUnit settings Rear panel settingsRotary controls Pin settings and labelling Switch off Switch on and offSwitch on OperationTone control Microphone/line controlsMusic controls Output controlsTechnical data ElectricalMechanical EnvironmentalPage For more information visit
Top Page Image Contents