Ericsson LBI-39055 manual System Tests, LOW-LEVEL Tests

Page 22

LBI-39055

Console Privilege Lists

Each console must be sent its privilege list from the CEC/IMC Manager as follows:

NOTE

System Manager database uploads must be accomplished before sending console privilege lists.

1.From the CEC/IMC Manager's "CEC/IMC MOM Options" main menu, select the "Console Configuration" option. This will display a sub-menu.

2.From this sub-menu, select the Console"

Privilege List" option.

3.From the "CONSOLE PRIVILEGE LIST UPLOAD" screen, enter the number of the console (1 - 32).

4.Select <F7> to send the privilege list data to the console.

Saving Database Information

At the C3 Maestro console, the following database information is saved automatically to the PC's hard disk drive after the last record is received. No user action is required:

User Profiles

Hardware Configurations

The following data is not saved automatically, but on demand or by prompt:

System Manager Upload Data

CEC/IMC Manager Upload Data

Module Set-Ups

To save upload data and module set-ups, press <F10> on either keyboard. This will save the data to the PC's hard disk.

SYSTEM TESTS

LOW-LEVEL TESTS

The following low-level tests verify the functionality of the PC's ability to control the Audio Tower's audio matrix

circuitry. It also verifies the line coupling circuitry and the speaker amplifier circuitry. Cross-point audio matrix switches are controlled(opened and closed) using the CTEST.EXE program. These low-level tests may be performed before any database initialization procedures. The tests do not represent a complete functional test of the console.

Recommended Test Equipment

Audio Signal Generator

(600-ohm output impedance)

Handheld Multimeter

Oscilloscope

600-Ohm Resistor

Test Leads

RJ-11 Modular Plugs (terminated with test leads)

Set-Up Procedure

Verify all equipment has been interconnected in accordance with the previous installation instructions presented in this manual.

At the Audio Tower, temporarily disconnect the RJ-11 plugs from the LINE A and LINE B modular jacks on the Audio PA Board (#1).

Verify the Audio Tower and the PC are powered up.

Start the CTEST program by typing CTEST followed by an <Enter> at the MS-DOS prompt. The current directory must be C:\UTIL. A copyright message and then the CTEST screen will appear.

Test Procedure

1.Send LINE A Input Audio to SPEAKER A

Using the audio signal generator, inject a 0 dBm 1kHz tone into the LINE A balanced input on the Audio PA Board (#1). The balanced input is the two outside contacts on the RJ-11 modular jack (yellow and black wires in a modular cable).

22

Image 22
Contents Table of Contents LBI-39055Table of Contents LBI-39055General − C3 Maestro Equipment InterconnectionsPersonal Computers Board SET-UPLogic Board Audio PA Boards Installation Into The PCFirmware PLUG-IN RS-422 Board OptionalAudio Matrix Board Interconnecting EquipmentBoard CEC/IMC Interconnections Software Installation and SET-UPControl Data Link MNP Options Remote Console Interconnections Via a 4-Wire Modem∙ Modem Options DTE OptionsPersonal Computer Audio LinksPC-To-Audio Tower Interconnect Cable − CEC/IMC-To-C3 Maestro Interconnections Co-Located LBI-39055 Video Display Monitor Dispatcher KeyboardStandard PC Keyboard Desk Mic if usedHeadset Jacks if used Boom/Gooseneck PTT and Monitor Switches if used− BOOM/GOOSENECK MIC Wiring Wire Color DB-9 PIN Number Boom/Gooseneck Mic if usedVolume Controller Box if used Footswitches if usedSpeakers if used Recorder Outputs if used Pager Input if usedRelay Outputs if used Console-to-CEC/IMC Audio Interconnections Call Director if equippedEquipment Room Grounding Console-to-Call Director Interconnections− I/O BOARD-TO-CALL Director Signal Descriptions Type Input OutputAC Power and UPS Equipment POWER-UP ProcedureSoftware Installation SET-UP Procedure PC Cmos SET-UP ProgramFile Directories and Contents Software Installation and UpgradesEditor Program Running the C3 Maestro Application Program Database Initialization Console User Profile ConfigurationSystem Manager Database Uploads System Tests LOW-LEVEL TestsSend Line B Input Audio to Speaker B Send Mic Audio To Line a & Line B OutputsHIGH-LEVEL Tests Test Audio PA Board #2 if installedCompletion