RULES AND REGULATIONS
When towing, an adequate safety chain must be fastened to the frame. See Towing Guidelines section in this manual.
Keep all inexperienced and unauthorized people away from the equipment at all times.
Unauthorized equipment modifications will void all warranties.
Check all fasteners periodically for tightness. Also check towing tongue bolt, lock nut and wheel lug nuts for wear.
Stop the engine and disconnect the spark plug before allowing anybody’s hands in the mixing drum.
NEVER pour or spray water over the engine or electric motor.
When towing, an adequate safety chain must be fastened to the frame. See Towing Guidelines section in this manual.
Keep all inexperienced and unauthorized people away from the equipment at all times.
Unauthorized equipment modifications will void all warranties.
Check all fasteners periodically for tightness. Also check towing tongue bolt, lock nut and wheel lug nuts for wear.
Stop the engine and disconnect the spark plug before allowing anybody’s hands in the mixing drum.
NEVER pour or spray water over the engine or electric motor.
Depending on type of mixer, test the ON/OFF switch for either the gasoline engine or electric motor before operating.The purpose of these switches is to shut down the engine or motor of the mixer
ALWAYS stand clear of the release drum lock. Move handle downward to empty the drum. Move handle upward to return to vertical position. Inspect for proper functionality before starting engine or engaging blades. Any binding of material between the mixing blades & drum will cause the handle to quickly rotate if not in the "up & locked" position.
DO NOT operate this equipment unless all guards and safety devices are attached and in place.
Refer to the HONDA Engine Owner's Manual for engine
WARNING — Manual Dump Drum Handle
Always stand clear of dump handle when equipment is in operation.
technical questions or information recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result.
TRANSPORTING
ALWAYS shutdown engine before transporting.
Tighten fuel tank cap securely and close fuel cock to prevent fuel from spilling.
Drain fuel when transporting equipment over long distances or bad roads.
MAINTENANCE SAFETY
NEVER lubricate components or attempt service on a running machine.
ALWAYS allow the machine a proper amount of time to cool before servicing.
Keep the equipment in proper running condition.
Fix damage to the equipment immediately and always replace broken parts.
Dispose of hazardous waste properly. Examples of potentially hazardous waste are used motor oil, fuel and fuel filters.
DO NOT use food or plastic containers to dispose of hazardous waste.
DO NOT pour waste, oil or fuel directly onto the ground, down a drain or into any water source.
WM120PH/SH HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #7 (09/15/11) — PAGE 9