MIXER COMPONENTS/HYDRAULIC COMPONENTS
17 | 18 |
Figure 4. Mixer Components (Stationary)
17.Adjustable Stabilizer Jack Stands — Use these jack stands (3) to adjust the mixer to the desired height.
18.Forklift Pockets
HYDRAULIC COMPONENTS
Figure 5 illustrates the hydraulic components used on the mixer.
1.Hydraulic Motor —
2.Hydraulic Dump Cylinder — When activated, this cylinder will cause the mixing drum to rotate to the dump position.This cylinder is provided only on mixers with hydraulic dump capability only.
3.Hydraulic Oil Sight Gauge — This gauge indicates the level and temperature of the hydraulic oil. For normal operation oil level should be visible at the midpoint on the sightglass.
4.HydraulicValve — Directional hydraulic control valve. Controls the direction of hydraulic fluid supplied to the dump cylinder and paddle shaft.
Figure 5. Hydraulic Components
5.Hydraulic Dump Lever — This lever is provided on mixers with hydraulic dump capability only. Pull lever outward to activate dump cylinder.
6.Hydraulic Paddle Blade Lever —
7.Pump — Supplies hydraulic fluid to the hydraulic control valve.
8.Hydraulic Oil Filter — 10 micron hydraulic filter. Filters out small particles that are harmful to the hydraulic system.
9.Strainer — Filters out large particles and debris that are harmful to the hydraulic system.
Figure 5 shows configuration for electric motor. Gasoline engine is configured in the same manner.
WM120PH/SH HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #7 (09/15/11) — PAGE 17