MIX N' GO MIXER — MAINTENANCE (GASOLINE ENGINE)
Maintenance
Perform the scheduled maintenance procedures as definded by Table 6 and below:
DAILY
■Thoroughly remove dirt and oil from the engine and control area.Clean or replace the air cleaner elements as necessary. Check and retighten all fasteners as necessary. Check the gearbox for oil leaks. Repair or replace as needed.
WEEKLY
■Remove the fuel filter cap and clean the inside of the fuel tank.
■Remove or clean the filter at the bottom of the tank.
■Remove and clean the spark plug (Figure 32), then adjust the spark gap to 0.024 ~0.028 inch (0.6~0.7 mm).This unit has electronic ignition, which requires no adjustments.
Figure 32. Spark Plug Gap
ENGINE OIL
1.Drain the engine oil when the oil is warm as shown in Figure 33.
2.Remove the oil drain bolt and sealing washer and allow the oil to drain into a suitable container.
3.Replace engine oil with recommended type oil as listed in Table 4. Engine oil capacity is .48 quarts (0.45 liters). DO NOT overfill.
4.Install drain bolt with sealing washer and tighten securly.
DANGER :
DO NOT use gasoline as a cleaning solvent, because that would create a risk of fire or explosion.
ENGINE AIR CLEANER
1.Remove the air cleaner cover and foam filter element as shown in Figure 34.
2.Clean foam element in warm, soapy water or nonflammable solvent. Rinse and dry thoroughly. Dip the element in clean engineoilandcompletelysqueezeouttheexcessoilfromthe element before installing.
Figure 34. Engine Air Cleaner
Figure 33. Engine Oil (Draining)
MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 27