MIX N' GO MIXER — BASIC ENGINE
Figure 5. Engine Controls and Components
INITIAL SERVICING
The engine (Figure 5) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions and details of operation and servicing.The engine shown above is a HONDA engine, operation for other types of engines may vary somewhat.
1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.
DANGER
Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT
attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.
2. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.
3. Engine ON/OFF Switch – ON position permits engine
| starting, OFF position stops engine operation. |
4. | Recoil Starter (pull rope) – |
| the starter grip until resistance is felt, then pull briskly and |
| smoothly. |
5. | Throttle Lever – Used to adjust engine RPM speed (lever |
| advanced forward SLOW, lever back toward operator |
| FAST). |
7. | Air Cleaner – Prevents dirt and other debris from entering | |
| the fuel system. Remove | |
| cannister to gain access to filter element. | |
8. | Choke Lever – Used in the starting of a cold engine, or in | |
| cold weather conditions. The choke enriches the fuel | |
| mixture. |
|
|
| Operating the engine without an air |
| NOTE | filter, with a damaged air filter, or a |
| filter in need of replacement will | |
allow dirt to enter the engine, causing rapid engine wear.
9. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.024 - 0.028 inch) Clean spark plug once a week.
10. Muffler – Used to reduce noise and emissions.
WARNING
Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.
11.Oil Drain Plug – Remove this plug to remove oil from the engine's crankcase.
6.Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop the flow of fuel.
12.Dipstick/Oil Filler Cap – Remove this cap to determine if the engine oil is low. Add oil through this filler port as recommended in Table 4.
PAGE 18