Yamaha DGC1B manual MID OUT Able

Page 6

HOST TO

 

 

L

 

 

 

R

 

 

 

 

I IN

 

L

ALOG

MID

 

NTRO

 

CD

CO

O/AN

 

 

AUDI

 

 

 

 

 

I

IN

 

 

 

 

MID

 

 

 

 

 

OUT

 

 

 

 

 

ABLE

 

 

 

 

L

C

 

 

CON

TRO

NO

 

 

 

PIA

 

 

TO

FOR

 

 

 

ST SE

LECT

HO

C2

C1

PMAC

 

MP IDI

 

(4)Insert the control cable into the D-SUB connector on the back of the Control Unit, then securely tighten the two screws attached to the connector. Be sure to check the orientation of the D-SUB connector when inserting the cable.

(5)Fit the “slots” of the metal suspension bracket containing the Control Unit to the screws mentioned in step (3).

(6)After mounting the Control Unit, push the Control Unit back as far as it will go and then tighten the three screws to secure the bracket.

(4)Raccorder le câble de commande au connecteur D- SUB situé au dos du boîtier de commande, puis serrer correctement les deux vis du connecteur. Prendre soin de vérifier l’orientation du connecteur D-SUB en raccordant le câble.

(5)Glisser les “fentes” du support métallique contenant le boîtier de commande sur les vis mentionnées à l’étape

(3).

(6)Après avoir installé le boîtier de commande, l’enfoncer jusqu’à l’extrémité et serrer les trois vis pour fixer le support.

(4)Schließen Sie das Steuerkabel an den D-SUB-Anschluss auf der Rückseite des Steuergerätes an, und ziehen Sie dann die beiden am Stecker angebrachten Schrauben fest an. Achten Sie beim Anschließen des Kabels auf korrekte Ausrichtung des D-SUB-Steckers.

(5)Hängen Sie die Schlitzlöcher des Metallhalters mit dem Steuergerät an die in Schritt

(3) montierten Schrauben.

(6)Nachdem Sie das Steuergerät montiert haben, schieben Sie es bis zum Anschlag nach hinten. Ziehen Sie dann die drei Schrauben zur Sicherung des Halters an.

Image 6
Contents Page Alleen voor klanten Nederland Special Message Section Important Safety Instructions Remarques MID OUT Able Mark III Series Welcome to the Yamaha DisklavierTM Trademarks & CopyrightEnglish Please keep this manual for future reference InterferenceHandling Batteries Table of Contents Using the PianoSmart Feature Using the AUX ConnectorsUsing the SmartKeyTM Feature Advanced Ensemble Song PlaybackChapter Setting Up Your Disklavier Connecting the Control UnitItems Supplied with the Disklavier Connecting the Power Cable Using the Remote ControlConnecting Other Equipment Basic Disklavier Terminology Chapter Names of Parts and Their Functions Control Unit Front PanelREC button Control Unit Rear Panel AUDIO/ANALOG MidiAmplifier, Speakers & Foot Controller Amplifier PanelRemote Control Part Select buttonsHandling Floppy Disks Chapter Disks Used with the DisklavierFloppy Disks Accidental Erasure ProtectionHandling CDs Compact DiscsInserting & Ejecting Floppy Disks InsertingMemory Disks Inserting & Removing CDsChapter Turning On/Off Your Disklavier Turning On DisklavierTurning Off Disklavier Hold down FUNC. and press Standby / on Setting the Internal CalendarCalendar Memory Press EnterMaking Backups of Demo Songs Press FuncChapter Display LCD and Drive Indicator Drive IndicatorDisplay LCD Type of CD Software Song FormatPedal Data Piano Data Velocity MetersPrevious/Next Display Indications CursorChapter Basic Playback Playing Back a Floppy Disk or a Memory DiskPlaying Back a CD Specifying a Disk Standard Audio CDsSpecify a disk Press PLAY/PAUSE Starting Playback Pausing PlaybackStopping Playback Press PLAY/PAUSE again to continue playbackUsing the Number Pad Selecting Songs with the Remote ControlUsing the Song Select Buttons Selecting Songs with the Control UnitNormal playback Press Stop to engage Pause Mode Fast Preview & ReviewTo review, press Fast Forward & Reverse Adjusting the Volume Balance indicator lights Adjusting the ToneBalancing Ensemble Volume TG Master Balance Press the Selector untilPlay back a CD Balancing the CD Volume CD Master BalancePress the Selector until the Volume indicator lights Press the Selector once moreChanging the Tempo Press Adjusting the Pitch of Audio CDsTransposing a Song With the c cursor next toChapter Repeat Playback All Song, Single Song, Random RepeatPress Play to start Repeat playback To set point B, press A-B again To cancel Segment A~B RepeatSegment A~B Repeat Press Play to play back the specified sectionSegment A~ Return & Pause Repeat Press Search Starting Playback from a Specified Point SearchSearch Enter the time that you want to search forHand or Right-Hand Canceling the LeftChapter Useful Functions for Learning Piano Piano PartOperating the Pedals Using the Built-in Yourself Metronome Press MetronomePlayback with the Metronome Metronome againTo stop the metronome, press Metronome again Using an Optional Foot Switch or Foot Controller Using a Start/Stop Foot SwitchUsing a Foot Controller to Control the Tempo During playback or in Stop mode, press Voice Chapter Playing the Keyboard with an Ensemble VoicePlaying the Keyboard with an Ensemble Voice Use the -/NO and +/YES buttons to select a voice numberTo cancel this function, press Voice again Generator TG Master Tune Tuning the ToneChapter Advanced Ensemble Song Playback Play a key on the Disklavier keyboardPlaying the Piano Parts on the Tone Generator With the c cursor next to Piano Part option, press EnterDisplaying Ensemble Voices Selecting Tracks for the Piano PartsOption Description Chapter Using the AUX Connectors AUX SmartKeyTM Software Chapter Using the SmartKeyTM FeatureUsing a SmartKey Disk Playing a song from the built-in SmartKey demo pieceWatch the piano keyboard for Press the Song Select Buttons to select SmartKey DemoPlaying a song from a SmartKey disk First key prompt and play thatUsing a CueTIME Disk CueTIMETM SoftwareInsert the disk into the disk drive Guide ControlTurning off the Prompt Repeat option for CueTIME disks Buttons to specify the song youKey Prompt Play the song Prompt Repeat FunctionUse the -/NO and +/YES buttons to select OFF Press Func Turning off the Prompt Repeat optionPlayback Considerations PianoSmart Playback Chapter Using the PianoSmart FeaturePianoSmart Specify the CD that is to be played backTemporarily Suspending Playback Specify a FD Smart PianoSoftPianoSmart Manual Adjustment Press twice, and return to the last but one screenTo Delete the SPS Adjustment Value of a Song When Recording a New Song When Re-recordingPianoSmart Recording When Re-recording Using a Different Song on the Same When you finish playing your song, press StopUse and to select an option, then press Enter 4c To end now, press STOP, and proceed to step To re-record, press PLAY/PAUSE, and recording will beginWhen Re-recording Using Another CD To end now, press STOP, and proceed to stepChapter Internal XG Tone Generator Voice & Drum Kit List Internal XG Tone Generator Basic Voice ListInternal XG Tone Generator Drum Kit List Voice # Display Name Full Name Reed