2. Raise A to the vertical position.
2-1Raise A to the vertical position, with the keyboard side on the bottom, and hold A securely.
CAUTION
Do not release A until you finish Step 4.
A
CAUTION
Do not tip A further than 90 degrees to avoid stress to the key cover and lid.
3. Attach B.
3-1Align the holes on A with those on B and hold A and B together.
3-2Finger-tighten six short screws (6x20 mm) start- ing with the top hole.
3-3Tighten the screws securely.
B
A
4. Attach C.
4-1Hold C so that the notch on the bracket will face toward left, then align the holes on A with those on C.
4-2Finger-tighten four short screws (6x20 mm) start- ing with the top hole.
21
Keyboard Stand Assembly
4-3Tighten the screws securely.
A
C
5. Assemble the pedal structure. | ENGLISH |
5-1Pass the pedal cord (that comes out from the rear of pedal box E) through a hole on the bracket of D, then pass it through the pipe.
D
E
5-2Align the holes on the bottom of E with the holes on the bracket of D, then attach E and D by tight- ening six small screws (4x6 mm). At this time, first tighten the two center screws, then tighten the rest of the screws.
5-3Pull the end of the pedal cord to eliminate any slack inside the bracket on D.
D 
E 
CAUTION
Hold E securely to avoid slippage.
