Yamaha H01 owner manual FCC Information U.S.A

Page 28

FCC INFORMATION (U.S.A.)

1.IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instruc- tions contained in this manual, meets FCC require- ments. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2.IMPORTANT: When connecting this product to acces- sories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Fail- ure to follow instructions could void your FCC authori- zation to use this product in the USA.

3.NOTE: This product has been tested and found to com- ply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/ uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of

other electronic devices. Compliance with FCC regula- tions does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfac- tory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corpo- ration of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

(class B)

IMPORTANT NOTICE FOR THE UNITED KINGDOM

Connecting the Plug and Cord

IMPORTANT. The wires in this mains lead are coloured in accordance with the following code:

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured makings identifying the terminals in your plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the termi- nal which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth terminal of the three pin plug.

• This applies only to products distributed by Yamaha-Kemble Music (U.K.) Ltd.

(2 wires)

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES,

INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA

BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU

FOND.

• This applies only to products distributed by Yamaha Canada Music Ltd.

(polarity)

• Ceci ne s’applique qu’aux produits distribués par Yamaha Canada Musique Ltée.

 

92

Image 28
Contents Digital Piano Special Message Section Please Keep this Manual English Connections Main Features AccessoriesStylish and sophisticated digital piano Authentic Acoustic Piano-like Touch Natural Wood KeyboardTable of Contents Panel Controls and Terminals EnglishBefore Using the H01 Opening the key cover and lidClosing the key cover and lid Lift open the key cover and fold it back- wardTurning the Power On Setting the VolumeUsing Headphones Press the Power switch to turnListening to the 50 Piano Preset Songs Press the Power switch to turn the power onAdjust the volume Listen the preset songsWhat is SMF Standard Midi File? Listening to songs in the USB Flash Mem- oryStart/Stop the song Data formatTo protect your data write-protect switch USB Flash MemoryTo connect the USB Flash Memory USB flash memorySpecify the track to all tracks ALL Specify the Song Track and Play the SongSpecify the track to 1 and 2 tracks 1+2 Selecting & Playing Voices Selecting VoicesKey DescriptionUsing the Pedals Damper Right PedalSostenuto Center Pedal Soft Left PedalSetting the Octave Setting the BalanceCombining Voices Dual Reverb in DualAdjusting Reverb Depth Adding Variations to the Sound ReverbSelecting a Reverb Type Key Reverb Type DescriptionFine tuning of the Pitch TranspositionTouch Sensitivity Setting the Touch Sensitivity TypeKey Touch Sensitivity Description Troubleshooting Problem Possible Cause and SolutionPlace a on top of the pads Keyboard Stand AssemblyHave a Phillips-head + screwdriver ready Attach B Raise a to the vertical positionAttach C Connect the cords Install the pedal structureReplace the groove covers Rotate the adjuster Raise aAppendix Music Rest / Notenablage / Pupitre / Atril YMR-01 FCC Information U.S.A North America WG91890