Roland owner manual Bulk Dump, Bulk Load, Using the GW-7 as a Midi Sound Module

Page 27

Off

The GW-7 will not synchronize to the external MIDI

 

device.

On

The GW-7 will receive MIDI Start (or Continue) mes-

 

sages, and will begin playing the backing or song re-

 

cording/playback in synchronization with the MIDI

 

Clock messages that are subsequently received.

 

When the GW-7 receives a Start message, it will wait

 

a short time for MIDI Clock messages to arrive. If

 

MIDI Clock messages are received, the GW-7 will syn-

 

chronize to them. If not, the GW-7 will use its own

 

tempo. In either case, you will be able to use MIDI

 

Stop messages to stop playback or recording.

P.Bend TxRx (Pitch Bend Message

Transmission/Reception)

(On/Off, default: On)

This is an on/off switch for Pitch Bend message transmission/ reception. These messages temporarily raise or lower the pitch of the keyboard mode Tone.

Mod TxRx (Modulation Message

Transmission/Reception)

(On/Off, default: On)

This is an on/off switch for Modulation message transmission/ reception. These messages apply vibrato to the keyboard mode Tone (control change CC#01).

Prog TxRx (Program Change Message Transmission/Reception)

(On/Off, default: On)

This is an on/off switch for Program Change message transmission/reception. These messages are used to select Tones.

Velocity Rx (Velocity Reception)

(On, 1–127, default: On)

This is an on/off switch for Velocity reception. This applies only to the velocity of Note messages received via MIDI. If this is On, the GW-7 will use the velocity value that it receives. Otherwise, the GW-7 will use the velocity value you specify here.

Clock Tx (Clock Message Transmission)

(On/Off, default: On)

This specifies whether MIDI Clock messages will be transmitted. Use this when you want a connected external MIDI device to synchronize to the GW-7.

StartStop Tx (Start/Stop/Continue Message Transmission)

(On/Off, default: On)

This specifies whether Start/Stop/Continue messages will be transmitted.

Song mode: Start/Stop/Continue

Style mode: Start/Stop

SongPos TxRx (Song Position Pointer Message

Transmission/Reception)

(On/Off, default: On)

This specifies whether Song Position Pointer messages will be transmitted/received to indicate the currently playing position in Song mode. If you don’t want this message to be transmitted or received, choose the Off setting. This is valid only if MODE [SONG] is lit.

MIDI Functions

Lyrics Tx (Lyrics Data Transmission)

(On/Off, default: Off)

When playing back Format 0 SMF music data, this allows lyrics imbedded in the data to be transmitted to an external device.

Bulk Dump

The GW-7’s User Tone data and User Performance data can be sent via MIDI and saved on an external sequencer or other MIDI device. Make settings on your external sequencer so that it is ready to record normal performance data, and perform the following steps on the GW-7.

User Style and User Song data cannot be transmitted via MIDI. Use USB to transfer this data. (p. 24)

1.Use a separately available MIDI cable to connect the GW-7’s MIDI OUT connector to your external sequencer’s MIDI IN connector.

2.Press [FUNCTION].

3.Use SELECT [ ][ ] to get the screen to indicate “Utility?”, and then press [ENTER].

4.Use SELECT [ ][ ] to choose “Bulk Dump?”

5.Press [ENTER]; the screen will prompt “Sure?”

6.Press [ENTER] again to execute the Bulk Dump.

If you press [EXIT], the procedure is canceled and you’re returned to the previous screen.

Bulk Load

GW-7 User Tone data and User Performance data saved on an external sequencer or other MIDI device can be received via MIDI (i.e., reloaded back into the GW-7).

User Style and User Song data cannot be received via MIDI. Use USB to transfer this data. (p. 24)

When you execute Bulk Load, the User Tone and User Performance data in the GW-7’s memory will be overwritten. You should save any important data on an external MIDI device before you proceed.

1.Power up the GW-7.

2.Use a separately available MIDI cable to connect the GW-7’s MIDI IN connector to your external sequencer’s MIDI OUT connector.

3.Transmit the bulk dump from your external sequencer to the GW-7.

Using the GW-7 as a MIDI Sound Module

Press [SONG] to put the GW-7 in Song mode.

27

Image 27
Contents Conventions Used in This Manual For the U.K Protect the unit from strong impact. Do not drop it Important Notes Contents Front Panel Panel DescriptionsRear Panel About the GW-7 Connecting External Equipment, Pedals, and SwitchesConnecting a Pedal and Switch IntroductionTurning the Power On/Off Playing Sounds from the Keyboard Keyboard ModeListening to the Demo Song Using the Metronome Restoring the GW-7 to Its Factory SettingsUsing Split Mode Using Dual ModeOctave Settings Keyboard Mode FunctionsSelecting the Tone for the Keyboard Mode Using the Favorite Tone FunctionParameter Range Explanation Editing a ToneEditing a Tone in Detail Saving a ToneUsing the GW-7 as a Midi Keyboard Controller Other FunctionsPress Select to return to the keyboard channel screen Playing Back a Backing Other Functions Related to Music Styles Selecting a Music StyleAdding Music Styles Deleting a Music StyleAssigning the D Beam Controller Function Performance Functions and EffectsPerformance Functions Beam ControllerSelecting a Performance Using Preset PerformancesPitch Bend and Modulation Assignable PedalOFF, on Performance ParametersUsing Effects Adjusting the Reverb or Chorus Send LevelEditing the Effects Enhancer Multi-Effect ListKeyboard Song FunctionsRecording a Song AllDeleting a Song Using a Foot Switch to Punch-In/OutRecording Another Song After Previously Recording Saving a SongSelecting and Playing a Song Moving the Playback Location of a SongMinus-One Playback System Settings USB Functions and System FunctionsTransferring Files via USB Parameter Range Explanation System Parameter FunctionsMidi Functions Midi ChannelsMidi Parameters Using the GW-7 as a Midi Sound Module Bulk DumpBulk Load Troubleshooting Sound Is Distorted Pitch Is WrongCho Dual, Cho Split, Rev Main, Rev Dual, Rev Split p Button Tone Category Tone ListsTone Lists Wind World Button Rhythm Category Drum SetsOHH Drum SetsPC 68 CC32 PC 85 CC32 Kick House Kick HipHop Kick SimpleKick SFX Name Tempo Time sign Music StylesDM7 Chord Intelligence Mode 1 settingGM7 Midi Imprementation Chart Backing Track SpecificationsGW-7 Workstation Sound GeneratorControl Pedal IndexSong For EU Countries For the USAFor Canada Africa Information