Yamaha PSR-270, Portatone manual Enable recording, Start recording, EZ Chord Recording

AUTO ACCOMPANIMENT — THE STYLE MODE

EZ Chord — Recording

1 Enable recording.

Press the RECORD button, repeatedly if necessary, until EZ Chord recording is selected. (“EZ” appears in the display and the “RECORD” indication flashes for a couple of seconds.)

RECORD indication flashes briefly.

STYLE 3EZ

RECORD	RECORD
ACMP ON

2 Select the desired EZ Chord bank.

Use the numeric keypad. Buttons 1 - 8 select EZ Chord banks #1 - #8, respectively.

3 Start recording.

— Clearing the Bank

Before recording, you may want to erase (clear) all recorded chords for the selected EZ Chord bank. For instructions on doing this, see “Clearing an EZ Chord Bank” on page 71.

Even if you’ve recorded over (erased) the factory set EZ Chord banks, you can restore the original banks. (See page 105.)

When the “RECORD” indication stops flashing (and is lit continu- ously), you can start recording. Recording chords in EZ Chord is essentially a three-step operation:

1)Select the desired block with the +/- buttons.

RECORD

ACMP ON

3-025

1 — 16 Block

17 — 32 Block

33 — 48 Block

49 — 64 Block

65 — 80 Block

81 — 96 Block

97 — 112 Block

113 — 128 Block

Indicates the	Currently selected
chord position.	block flashes.

2)At the selected block, record the desired chord. You can do this in one of two ways:

•Play Multi Fingering chords in the auto accompaniment section. (See page 56.)

•Enter the chord root and name manually from the ROOT and CHORD TYPE section of the keyboard.

RECORD
ACMP ON		Indicates the
	M7
		recorded chord.
3-025
Bank number	Block number (128 are available in a bank)

68

66