AC POWER SECTION
The AC POWER SECTION explains the proper connections/method to supply AC power to your XR 800F+. Please pay close attention to the precaution(s) noted below in order to ensure both personal and equipment safety.
1. | A/C POWER INLET: | 1 | 3 | 2 |
| This receptacle is for the IEC line cord |
|
|
|
| (included), which provides AC power to the |
|
|
|
| unit. Connect the line cord to this connector |
|
|
|
| and to a properly grounded AC supply. |
|
|
|
| Damage to the equipment may occur if an |
|
|
|
| improper line voltage is used. (See voltage |
|
|
|
| marking on unit.) Never remove or cut the ground pin of the line cord plug. This unit is | |||
| supplied with a properly rated line cord. When lost or damaged, replace this cord with one of | |||
| the proper ratings. |
|
|
|
2.POWER:
This is the mixer’s main power switch. The Power LED indicator (20) will illuminate when the unit is powered.
3.FUSE:
This is the main safety fuse for the AC line voltage. Only replace the fuse with one of the exact same type and rating. IF THE FUSE CONTINUES TO OPEN, DO NOT REPLACE WITH A LARGER FUSE. TAKE THE UNIT TO AN AUTHORIZED PEAVEY SERVICE CENTER!
WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE.
POWER AMPLIFIER SECTION
The POWER AMPLIFIER SECTION will explain the proper method of connecting your XR 800F+ to your speakers. This is a very versatile area of the XR 800F+. However, it is important that you follow the precautions to insure safe operating impedances and avoid improper connections.
4. | PARALLEL LEFT/RIGHT SPEAKER OUTPUTS: | 4 | 4 |
| These 1/4" jacks are the outputs for the two |
|
|
| internal amplifiers. Two cabinets can be |
|
|
connected to each amplifier, as long as the combined impedance of the cabinets is not less than 4 ohms. (i.e., two 8 ohms cabinets in parallel = 4 ohms, four 16 ohms speakers in parallel = 4
ohms, etc.) The outputs from these jacks are determined by the System Mode Switch (19).
5