Peavey XXRR 880000FF++ manual Lo Eq, Digital Effects, Pan, Peak LED, Channel Fader

26

27

26.GAIN:

With your Channel Fader (34) and the master faders (23) set to the “0” position, adjust this control for desired volume through the system. If the red LED lights, it is set too high.

27.HI EQ:

A shelving type of active tone control that varies the treble frequency levels ±15 dB at 12 kHz. It is designed to remove noise or to add brilliance to the signal, depending on the quality of the source. (The high control can also be found on Channels 7 through 9.)

28	28. MID EQ:
	Mid ±15 dB. This control sets the amount of cut or boost at the
	mid-frequency (850 Hz). The mid control can also be found on
29	Channels 7 and 8.

	29.	LO EQ:
		A shelving type of active tone control that varies the bass frequency
		levels ±15 dB at 70 Hz. It will add depth to thin signals, or clean up
30		muddy ones. (The low control can also be found on Channels 7
		through 9.)

30.MON:

Adjusts the level of the channel signal (pre-EQ) that is added to the

31		Monitor mix. (The Monitor control can also be found on Channels 7
		through 9.) This control is independent of the Channel Fader
		control (34).
32	31.	DIGITAL EFFECTS:
		This control varies the level into the digital effects processor bus by
		adjusting the signal level from the particular channel to the digital
		processor. The channel Gain (26) control also affects this level. The
	33	digital effects send is after the channel fader and is therefore
		affected by the channel fader setting.
	32.	PAN:
		Sets the channel’s position in the L/R stereo field. In the stereo
		Channels (7, 8 and 9) this control acts as a balance control
		between the two separate inputs.

34	33.	PEAK LED:
		Indicates when the signal input is too strong and signal clipping is
		present. A clipped signal may damage your speakers.

34.CHANNEL FADER:

Sets the signal level sent to the Left and Right bus. (This feature

can also be found on Channels 7 through 9.)

10