35. AC Power Inlet: This is the receptacle for | 35 | 36 | 37 | ||||||
the supplied IEC line cord. This provides | |||||||||
|
|
|
|
|
|
| |||
AC power to the unit. Connect the |
|
|
|
|
|
|
| ||
supplied line cord to this connector to |
|
|
|
|
|
|
| ||
provide power to the unit. Damage to the |
|
|
|
|
|
|
| ||
equipment may result if improper line |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
voltage is used (see line voltage markings |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
on the unit). |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
36. Power: The main power switch for the XR600G. The power on LED indicator (front) will light when the unit is powered.
37. Fuse: This is the main safety fuse for the AC line voltage. Only replace with a fuse of the exact type and rating. If the
fuse continues to open‚ do not over fuse. Take the unit to an authorized Peavey service center.
VENTILATION: ALLOW 6" (15.5 CM) ON ALL SIDES FOR
PROPER VENTILATION.
38 | 39 |
38 & 39. Main/Monitor and Main Outputs: These 1⁄4" jacks are the amplifier’s outputs. By connecting a speaker cable to these jacks and to a speaker cabinet‚ you complete the signal chain. You will notice there are two pairs of jacks. The two pairs are your two amplifier outputs. Two cabinets can be connected to each channel as long as the combined impedance of the cabinets is not less than 4 ohms. (i.e.‚ two 8 ohm cabinets in parallel = 4 ohms‚ four 16 ohm cabinets in parallel = 4 ohms‚ etc.)
11