Peavey XR 600G operation manual XR600G · Technical Specifications, XR600G · Input Specifications

XR®600G · Technical Specifications

XR600G · Input Specifications:

Function	Input Z	Input Gain Control		Input Levels		Bal	Connector
	(ohms) Min	Settings	Min**	Nominal*	Max	Unbal
Lo-Z Mic (150 ohms)	2k	Max w/o pad (50dB)	-59dBu	-29dBu	-11dBu	Bal	XLR Pin 1 Gnd
		Max w/pad (25dB)	-34dBu	-4dBu	+14dBu		Pin 2 (+)
							Pin 3(-)
Line Input	22k	Max w/o pad (30dB)	-27dBu	+2dBu	+21dBu	Unbal	1⁄4" TRS; Tip (+)
		Max w/pad (5dB)	-2dBu	+27dBu	+46dBu		Ring (-)
							Sleeve Gnd
Tape	20k	Max Gain (30dB)	-26dBu	+4dBu	+21dBu	Unbal	RCA jacks

0dBU = 0.775V (RMS)

**Minimum input level (sensitivity) is the smallest signal that will produce nominal output (4dBu) with channel and master controls set for maximum gain.

*Nominal settings are defined as all controls set at 0dB (or 50% rotation for rotary pots)

XR600G · Output Specifications:

Function	Minimum Load Z (ohms)		Output Level		Bal	Connector
		Nominal		Max	Unbal
Main	600	+2dBu		+21dBu	Unbal	1/4" Phono Tip (+)
						Sleeve Ground
Monitor	600	+2dBu		+21dBu	Unbal	1/4" Tip (+)
						Sleeve Ground
Tape	10k	-10dBu		+10dBu	Unbal	RCA

+2dBU = 0dBV = 1V (RMS)

Gain:
Mic Input to Main Output	60dB (Max Gain)
Line Input to Main Output	30dB (Max Gain)
Frequency Response:
Mic Input to Main Output	20Hz–20kHz +0dB/-1dB
Line Input to Main Output	20Hz–20kHz +0dB/-1dB
To Power Amplifier Output	20Hz–20kHz +0dB/-1dB

Total Harmonic Distortion:

<0.01% 20Hz–20kHz Mic Input to Main/Monitor Output at Nominal Level (20Hz–80kHz BW) <0.01% 20Hz–20kHz Line Input to Main/Monitor Output at Nominal Level (20Hz–80kHz BW) <0.005% Typical @ 1kHz

Graphic Equalizer:
Filter Bandwidth	1 Octave
Filter Frequencies	63‚ 125‚ 250‚ 500‚ 1k‚ 2k‚ 4k‚ 8k‚ 16k
Maximum Boost and Cut	+12dB Boost‚ -12dB Cut

14