Peavey XR 600G operation manual Ratio

XR600G · Hum and Noise:

Output	Residual Noise	Test Conditions
	Ref: 4dBu
Main	-100dB	All controls down
	-90dB	1 channel nominal‚ Master nominal
	-81dB	Master Fader Nominal‚ Channel Faders Nominal‚ Mic Inputs Terminated @ 150ohms
Monitor	-100dB	All controls down
	-90dB	1 channel nominal‚ Master nominal
	-82dB	Master Fader Nominal‚ Channel Faders Nominal‚ Mic Inputs Terminated @ 150ohms

(Hum and Noise measurements: 22Hz–22kHz BW)

S/N Ratio:

>85dB below rated power output‚ Mic/Line to Speaker Output

Equivalent Input Noise (EIN):

-121.5 dBu (Input terminated with 150ohms)

Crosstalk:

>80dB Adjacent Input Channels (20Hz–20kHz) >70dB Left to Right Outputs (20Hz–20kHz)

Common Mode Rejection Ratio (Mic Input):

50dB minimum (20Hz–20kHz)

60dB typical @ 1kHz

XR600G · Power Amplifier Specifications:

Power Section:	DDT Dynamic Range:	Input Sensitivity:
400 SC Module with DDT	Greater than 26dB	1.225 V RMS for rated power output
Power and Load:	DDT Maximum Distortion:	Input Impedance:
210W RMS per channel into 4 ohms	Below 0.5% THD for 6dB overload	11k ohms
150W RMS per channel into 8 ohms	Below 1% THD for 20dB overload	Power Requirements:
Frequency Response:	Hum and Noise:	DOM: 120VAC 60Hz 360W nominal
20Hz–20kHz +0dB/-1dB @ rated	95dB below rated power level (200w)	EXP: 220-230VAC/240VAC 50/60Hz
power	Damping Factor:	360W nominal
Total Harmonic Distortion (THD):	Greater than 100 @ 1kHz‚ 4 ohms
<0.02% @ rated output @ 1kHz

XR600G · Product Weight and Dimensions:

Width: 19.125" Height: 10.875" Depth: 11.000" Weight: 35.600 lbs

15