Peavey UMA 752 specifications Thd, Xfmr

Specifications UMA™ 752 MIXER/AMPLIFIER

Specifications

Rated output power: 75 Watts
Output regulation:
Direct out:	<0.5 dB
Transformer out:	<1.0 dB
Frequency response:
Power Amplifier:	±0.5 dB, 20 Hz to 20 kHz,
	direct out
	±1.0 dB, 50 Hz to 20 kHz,
	transformer out
Preamplifier:	±1.0 dB, 20 Hz to 20 kHz
THD:
Power Amplifier:	0.05% (1 kHz)
Preamplifier:	0.10% with nominal gain
	settings
Power bandwidth (±3 dB):
Direct out:	<10 Hz to 70 kHz
Transformer out:	30 Hz to 40 kHz

Signal/noise:
(22 Hz — 22 kHz) typical
All controls CCW:		-100 dB
All controls nominal (5):		-90 dB
Level controls CCW and master level CW:
		-80 dB
Outputs:
Direct out:	4 Ohms
XFMR:	Balanced 8 Ohms (25 V),
	70 V, 100 V
Ch. 4 out:	1 V nom., +21 dBu max.
	at 100 Ohms

Pre out:	1 V nom.; +21 dBu max.,
	at 100 Ohms
Inputs:
Channel 1:	Mic 1 mV at 1.8 k Ohms
	(XLR or screw terminals)
	Tel 100 mV at 20 k Ohms
	(Screw terminals)
Channel 2:	Mic 1 mV at 1.8 k Ohms
	(Screw terminals)
	Line 100 mV
	at 20 k Ohms
	(Screw terminals)
Channel 3:	Line 100 mV
	at 20 k Ohms
	(Screw terminals)
Channel 4:	Line 100 mV
	at 20 k Ohms
	(Screw terminals)
	Stereo 316 mV
	(-10 dBV) at
	4.0 k Ohms
	(RCA jacks)
Power in:	1 Volt at 20 k Ohms
Tone controls:
Bass:	±10 dB at 100 Hz
Treble:	±10 dB at 10 kHz

Front panel controls and indicators: Channel 1 level control Channel 2 level control Channel 3 level control Channel 4 level control

Bass control Treble control