SPECIFICATIONS
Rated Power & Load:
Power specs measured with T. Dynamics @ 10
65 W RMS into 8 ohms
4 ohms not recommended
Low&High @ 10 Mid @ 0
Pre & Post Gain @ 10 Gain & Thrash, Off (Out) Normal Levels are with normal
volume @ 5
Minimum Levels are with normal volume @ 10
Effects Return:
Impedance: High Z, 22 K ohms
Designed Input Level: - 10 dBV, 0.3 V RMS
(Switching jack provides Effects Send to Effects Return connection when not used)
System Hum & Noise
Power @ Clipping: (Typically)
(5% THD, 1 kHz, 120 V AC line)
65 W RMS into 8 ohms
Frequency Response:
+O, 3 dB, 60 Hz to 20 kHz, @ 50 W RMS into 8 ohms
Preamp High Gain Input:
Impedance: High 2, 1 M ohm
Nominal Input Level:
Minimum Input Level:
Maximum Input Level: 0 dBV, 1VRMS
@ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
68 dB below rated power
Equalization:
Special low, mid, & high passive
type EQ
Push Bright: +6 dB @ 2 kHz
Hum & Noise:
Greater than 78 dB below rated power
Power Consumption:
200 W @ 50/60 Hz, 120 V AC (Domestic)
Preamp Low Gain Input:
Impedance: High Z,44 K ohms
Nominal Input Level:
Minimum Input Level:
Maximum Input Level: 6 dBV, 2VRMS
Push Thrash:
Push Gain: Increases Lead gain
External Footswitch Functions:
Lead Channel Defeat (when selected with button)
Reverb Defeat
PREAMP SECTION
The following specs are measured
@1 kHz with the controls preset as follows:
Push Bright, Off (Out) Channel Select Normal (Out)
Effects Send:
Load Impedance: 1 K ohm or greater
Nominal Output Level:
REVERB LEVEL
HIGH GAIN
FOOTSWITCH
SWITCH
INPUTLOGIC
PRE
FOOT
SWITCH
PUSH
BRIGHT
CLEAN 4
BLOCK DIAGRAM
5