Peavey 40/EFX owner manual Rear Panel

Page 28

REAR PANEL

 

 

 

Triple XXX® 40

 

 

 

27

28

29

30

31

Triple XXX® 40 EFX

34

 

 

 

 

 

 

(27)Fuse

A fuse is located within the cap of the fuse holder. This fuse must be replaced with one of the same type and value to avoid damaging the amplifier and voiding the warranty. If the amp repeatedly blows the fuse, it should be taken to a qualified service center for repair.

Warning: The fuse should only be replaced after the power cord has been disconnected.

(28)Ground Polarity Switch

This three-position, rocker-type switch should normally be placed in the center (0) position. If hum or noise is noticed coming from the speaker enclosure(s), the switch may be placed in the “+” or “-” position to minimize hum/noise. If changing the polarity does not alleviate the problem, consult your authorized Peavey dealer, the Peavey factory or a qualified service technician.

(29)Remote Switch (Triple XXX® 40 only)

This 1/4" connector is provided for the connection of the remote footswitch. The footswitch cable should be connected before the amp is powered up. See the FOOTSWITCH section of this manual for explanation of switch operation.

(30)Speaker Output

This 1/4" mono (TS) jacks is provided for the connection of speaker enclosure(s). Minimum speaker impedance is 16 ohms.

(31)Damping Switch

This 3-position switch allows adjustment of the amplifier’s damping factor. Damping is the ability of an amplifier to control speaker cone motion after a signal disappears. A high damping factor (TIGHT) reduces cone vibration quicker than a low (LOOSE) factor. This switch works much like the resonance and presence controls on other Peavey amps, if those controls were turned simultaneously. If the DAMPING SWITCH is changed, the volume of the amp will also change and require re-adjustment.

(32/33) Effects Send/Return

These 1⁄4" mono (TS) jacks allow signal to be sent to‚ and returned from‚ external effects and/or signal processors. Using shielded cables with 1⁄4" mono (TS) phone plugs, patch from EFFECTS SEND to the input of the external device and from the output of the external device to EFFECTS RETURN. Only devices that do not increase signal gain should be used in this effects loop (chorus, delay, reverb, etc.).

(34)Remote Switch (Triple XXX® 40 EFX only)

This seven-pin DIN connector is provided for the connection of the remote footswitch. The footswitch cable should be connected before the amp is powered up. See the FOOTSWITCH section of this manual for explanation of switch operation.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Triple XXX 40/EFX Page Important Safety Instructions Features EnglishInput Triple XXXBottom Standby Switch Power SwitchEFX Adjust Volume BoostTriple XXX 40 EFX Channel SelectTriple XXX Triple XXX 40 EFX Volume Boost Button 37-44 Mode SelectPreset Select Mode Channel Select ButtonCreating and Storing Custom Presets EFX Select ModeTweak Adj Parameters Page Triple XXX 40 Block Diagram Triple XXX 40 EFX Block Diagram Power amplifier section Rated Power & LoadSignal/Noise Power consumptionFrançais CaractéristiquesEntree Input Volume Boost modèle non-EFX uniquement Parametres DU Controle EFX ADJ Rear Panel Footswitch Chorus Wet/Dry mix Page Specifications DU Español Caracteristicas12 Volumen EntradaLED DE Activación DEL Canal Ultra 11 GananciaSelector RHYTHM/CRUNCH LED DE Activación DE Canal RHYTHM/CRUNCHInterruptor Standby Interruptor DE CorrienteBoost DE Volumen Selector DE CanalAjuste DE Efectos Parámetros DE Ajuste DE EfectosRear Panel 36 Botón DE Boost DE Volumen Modo de Selección de Presets35 Botón DE Selección DE Canal 37-44 Selección de ModoCreando y Salvando Presets Personalizados Parámetros de Cambios específicosModo de Selección de EFX Page Especificaciones Deutsch MerkmaleUltra-Channel-LED POWER-SCHALTER Netzschalter STANDBY-SCHALTERTremolo Erhöhung der Rate Funk Wah Ground-Polarity-Schalter Fernbedienungsschalter nur Triple XXXLautsprecherausgang Damping-SchalterFernschalter nur Triple XXX 40 EFX Volume-Boost-TasteChannel-Select-Taste Funktionen ZUR Feineinstellung Tweaks Tweak-Adj-ParameterErstellen und Speichern persönlicher Presets Spezifikationen Page Peavey Electronics Corporation Limited Warranty 2003

40/EFX specifications

The Peavey 40/EFX is a compact and versatile amplifier that has been designed for musicians who require a reliable and feature-packed combo amp. Known for its impressive sound quality and user-friendly operation, the Peavey 40/EFX is suitable for a wide range of applications, from practice sessions to small gigs.

One of the most notable features of the Peavey 40/EFX is its power output. With 40 watts of power, this amplifier is capable of delivering a robust sound that can easily fill smaller venues and practice spaces. The 12-inch speaker provides a warm and rich tone, making it an excellent choice for guitarists and other musicians who value sound quality.

The Peavey 40/EFX also boasts a built-in effects processor, which includes a variety of effects such as reverb, chorus, and delay. This allows musicians to easily enhance their sound and experiment with different tonal textures without the need for additional pedals or gear. The effects can be easily adjusted using intuitive controls, making it straightforward for players to find the right sound for their needs.

In terms of connectivity, the Peavey 40/EFX is equipped with multiple input options, including a 1/4-inch instrument input and an auxiliary input for connecting external devices like smartphones or tablets. This versatility makes it an excellent choice for jam sessions, as musicians can easily connect backing tracks or play along with their favorite songs.

The built-in tuner is another key feature that sets the Peavey 40/EFX apart from its competitors. Musicians can quickly and accurately tune their instruments directly through the amplifier, ensuring they are always performance-ready.

Durability and portability are also prominent characteristics of the Peavey 40/EFX. Its rugged construction ensures that it can withstand the rigors of transport, making it an ideal companion for musicians on the go. Compact in design, it is easy to carry, fitting neatly into most vehicles without taking up much space.

Overall, the Peavey 40/EFX is a reliable and feature-rich amplifier that caters to a variety of musical styles and performance settings. Its combination of power, sound quality, built-in effects, and portability make it an excellent choice for both aspiring and seasoned musicians alike. With the Peavey 40/EFX, players can enjoy a high-quality sound experience without compromising on convenience.
Top Page Image Contents