Fostex FD-4 Executing Track Exchange, Swapping mono track data, Select the tracks to swap data

	Editing Tracks
Executing Track Exchange
	• Swapping mono track data
1. While the FD-4 is stopped, press the EDIT key repeatedly
until [TRK Exchg] flashes on the display.	1. When [L–R] is flashing, turn the JOG dial.
Alternatively, you can press the EDIT key, then use the	Turning the JOG dial allows you to select a mono track
JOG dial.	from [1], [2], [3], [4], [L], and [R] in the left column.
	The right column continues to indicate [1].
	For example, if you select [4] in the left column, the
	display indicates [4<>1], meaning you can swap data
	between tracks 4 and 1.

SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH

2. Press the EXECUTE/YES key.
					SYNC OUT	DRIVE
The display shows the track selection.					CLK		SCSI
					AUTO	A.PUNCH
The current display shows that you can swap two-track
data between Additional tracks L/R and rear tracks 1–2.
If you wish to select other tracks, follow the steps below.				2. To select a number in the right column, press the
				HOLD/> key, the REWIND button, or the F FWD button
				to move the flashing cursor to the right column, then
				use the JOG dial to select the desired number.
				* When you swap data between mono tracks, the indications [4<>1]
	CLK		SCSI
	SYNC OUT	DRIVE
	AUTO	A.PUNCH		and [1<>4], for example, mean the same thing — swapping data
				between tracks 1 and 4.

3.Select the tracks to swap data.

•Selecting Additional tracks L–R and Real tracks 3–4:

1.Press the HOLD/> key, the REWIND button, or the F FWD button to move a flashing cursor on [L–R] (left) to [1–2](right).

SYNC OUT	DRIVE
CLK		SCSI
AUTO	A.PUNCH

2.Turn the JOG dial to change flashing [1–2] to flashing [3–4].

<Note>

If you select the same tracks for swapping mono track data, the setting is ignored. The FD-4 will indicate [Select Err] for a short mo- ment, then return to the previous display.

4.Press the EXECUTE/YES key.

[Exchange] lights up and the swapping operation is completed immediately.

The FD-4 indicates [COMPLETED !], then returns to the previous Time Base display.

*You cannot play data or check the REC END point on the Additional tracks. To do so, you need to move the data to a Real track.

If you load back-up data from an external DAT recorder, the data maintains the same condition as when you previously saved it to DAT.

SYNC OUT

CLK

AUTO

DRIVE

SCSI

A.PUNCH

61