Important things to learn, Front and rear panel

1. Introduction

Important things to learn

Front and rear panel

Front panel

1Effect select knobs

These knobs select the effect model used in each effect block.

2Effect block LEDs

The LED will light for effect blocks that are in use. During editing, the LED of the selected effect block will blink.

3Effect block select switches

Press these switches to turn each effect block on/off.

4Value LEDs

These LEDs will light to indicate the value knobs that can be used for the selected effect model. From the left, they correspond to value knobs 1—5.

5Value knobs

When editing, rotate these knobs to modify the value of the parameter assigned to each knob. From the left, these are value knobs 1—5.

When not editing, these knobs control the parameters of the effect that is assigned to the DRIVE-AMP effect block by the selected program. (Refer to p.12, “Quick editing for the DRIVE-AMP effect block.”) In general, this is the most important tone shaping effect in a multi effect set up.

6Program LEDs

The LED of the currently selected program number will light.

7Program switches

Use these switches to select a program.

8Bank switch

Each time this switch is pressed, the bank number will increase by one. The bank number will decrease by one if you simultaneously press the bank switch and program switch 4.

9Expression pedal

This pedal controls the effect that is selected for the PEDAL effect block.