LCD and control panel
1Name display
This shows the program name, effect name, or parameter name, as appropri- ate for each operation.
2Edit icon
This will light if the selected program has been edited. It will blink if the program is currently being edited.
3Phrase trainer icon
This will blink when you are in Phrase Trainer mode.
4Metronome icon
This will light when the metronome is on. It will blink while the metronome tempo or level is being adjusted.
5MASTER/VALUE display
This indicates the master level or parameter values.
6
Use this switch to adjust the amount of noise reduction or the level of each program.
7RENAME switch
Use this switch to modify the name of a program.
8Metronome LED
This LED will blink in time with the metronome tempo.
9EXIT switch
From any state, you can press this to return to Play mode.
0WRITE switch
Use this switch to save an edited program.
ACursor switches ( 
, 
)
Use these switches to select the parameter that you wish to edit, or when modifying the name of a program.
BMASTER/VALUE switches (▲ , ▼ )
Use these switches to modify the master level or the value of a parameter.
CPedal LED
This LED indicates the on/off status of the PEDAL effect, or the recording status when the Sample & Play function is being used.
DBank number display
This shows the bank of the selected program. When a user program is selected, the decimal point “.” located at the lower right of the bank number will light.
1. Introduction
5