Nilfisk-ALTO S-6 user manual Input, Output

Page 10

- MAIN MIX OUTPUT

19

This stereo output is controlled by the Main Mix Level on the front panel and will send the audio signal to an amplifier. The output level can be varied from - to +15dB.

- 2-TRACK IN/OUT

20

Input

 

Use the Tape input if you wish to listen to your Mix from a Taper Recorder or DAT, You can the signal coming form the Taper Recorder either to a pair of studio monitor using the Control Room assignment on the front panel or you can also send the signal directly to the Main Mix.

Output

20

MAIN MIX OUTPUT

2-TRACK IN/OUT

L

LEFT

R

RIGHT

TAPE IN TAPE OUT

19

These 1/4" TRS sockets will route the main mix into a tape recorder.

STEREO

AUX RETURN

LEFT(MONO)

RIGHT

AUX SENDS

PHONES

CONTROL ROOM

OUTPUT

LEFT

RIGHT

LTOR S-6

6-CHANNEL MIXING CONSOLE

21

22

23

24

- STEREO AUX RETURN

21

Use these stereo 1/4" phone socket to return the sound of an effect unit or sound processor to the Main Mix. Alternatively you can use them as an extra auxiliary input.

- AUX SENDS

22

This 1/4" phone socket is used to send out the signal from the AUX Bus to external devices such as effects and sound processors.

- PHONES23

This socket will send out the signal mix to a pair of headphones.

- CONTROL ROOM OUTPUT

24

These 1/4" phone sockets will be used to send the signal to Studio Monitor speakers or to a second set of PA.

9

Image 10
Contents Channel Mixing Console Power Supply Safety Related SymbolsImportant Safety Instructions External ConnectionPreface Table of Contents Introduction AUX Phantom Power +48 Volts MIC/LINE channels2 MID 1 HI3 LOW Track signal path PWRInput OutputPower 18VACInstallation and Connection Some Final Tips on Wiring Configuration Stereo TRS Jack PlugFor the Experts WHO Want to Know More AfterSystem Block Diagrams Technical Specification Warranty Registration Card Seikaku Technical Group Limited