Nilfisk-ALTO S-6 user manual For the Experts WHO Want to Know More, After

Page 14

6.FOR THE EXPERTS WHO WANT TO KNOW MORE

As we have told you previously in this Manual, the Aux Send Control both on Mono and stereo channels is factory wired as POST-FADER. If you have some skill in electronic components soldering you can modify this setting and have all your AUX sends configured as PRE-FADER.

Aux

(PRE)		(PRE)
POST	Disconnect	POST
POST	the POST route	POST
	the POST route

Solder the PRE route

Before

After

Modification on mono and stereo channels

Image 14

Contents Channel Mixing Console Power Supply Safety Related SymbolsImportant Safety Instructions External ConnectionPreface Table of Contents Introduction AUX Phantom Power +48 Volts MIC/LINE channels3 LOW 1 HI2 MID Track signal path PWRInput Output Power 18VACInstallation and Connection Some Final Tips on Wiring Configuration Stereo TRS Jack PlugFor the Experts WHO Want to Know More AfterSystem Block Diagrams Technical Specification Warranty Registration Card Seikaku Technical Group Limited