Nilfisk-ALTO S-8 Rear Panel Description, PHANTOM4, AC Inlet with Fuse Holder, Main MIX Output

4.12REAR PANEL DESCRIPTION

25 4

ON

OFF

POWER PHANTOM

fuse 250V a with only Use

CAUTION:			CAUTION
			RISK OF ELECTRIC SHOCK
REPLACE WITH THE SAME TYPE FUSE AND RATING			DO NOT OPEN
		WARNING: SHOCK HAZARD - DO NOT OPEN
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
		AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
	MAIN MIX OUTPUT			CONTROL
	(BAL/UNBAL)			ROOM OUTPUT
RIGHT	LEFT

2	1	2	1	LEFT	LEFT
	3		3
AC INPUT
EUROPE
210-240V 50Hz
Fuse:T250mAL				RIGHT	RIGHT

RATED POWER CONSUMPTION: 18W

26

- POWER 25

USA / Canada

100-120V 60Hz

Fuse:T500mAL

UK / Aust

240V 50Hz Fuse:T250mAL

27 28

This switch is used to turn the Main Power ON and OFF.

- PHANTOM4

This switch will apply +48 Volt Phantom Power only to the 5 XLR microphone inputs. Never connect microphones when the Phantom Power is on already.

- AC INLET WITH FUSE HOLDER 26

Use it to connect your S-8 to the Main AC with the supplied AC cord. Please check the Voltage available in your Country and make sure the voltage is identical to the values marking on the product. Replace the fuse with the same type by the qualified personnel only

- MAIN MIX OUTPUT 27

This stereo output is supplied both with XLR and 1/4" jack socket and it is controlled by the Main Mix Level on the front panel. It will send the audio signal to an amplifier. The output level can be varied from - to +15dB.

- CONTROL ROOM OUTPUT 28

These 1/4" phone sockets will be used to send the signal to Studio Monitor speakers or to a second set of PA.

13