Nilfisk-ALTO S-8 user manual Ready to START?

Page 7

3.READY TO START?

3.1Please check the AC Voltage available in your Country before connecting your S-8 to the AC socket.

3.2Be sure that the main power switch is turned off before connecting the Mixer to the AC socket. Also, you should make sure that all Input and Output Controls are turned down. This will avoid damages to your speakers and avoid excessive noise.

3.3Before turning on the S-8 you shall connect it to a power amplifier and turn-on the mixer BEFORE the power amp- lifier. Once you have finished your working session you shall turn the mixer off AFTER the power amplifier.

3.4Before disconnecting the S-8 always turn-off the Power switch.

3.5Do not use solvents to clean your S-8. A dry and clean cloth will be OK.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Channel Mixing Console External Connection Safety Related SymbolsImportant Safety Instructions Power SupplyPreface Table of Contents Introduction Features Ready to START? Channel Mixing Console Control ElementsMono MIC/LINE channels Input Level settingLOW-CUT Filter Stereo Inputs Level AUX SendsPAN PeakMaster Section AUX Send 1 Track IN/OUT InputOutput Stereo AUX ReturnMain MIX Output Rear Panel DescriptionPHANTOM4 AC Inlet with Fuse HolderInstallation and Connection Stereo TRS Jack Plug Some Final Tips on Wiring ConfigurationTapped Connection Direct Output Lead Modification on mono and stereo channels For the Experts WHO Want to Know MoreSystem Block Diagrams Technical Specification Terms and Conditions WarrantyWarranty Registration Card Return NoticeSeikaku Technical Group Limited
Top Page Image Contents