Nilfisk-ALTO S-8 For the Experts WHO Want to Know More, Modification on mono and stereo channels

Page 18

6. FOR THE EXPERTS WHO WANT TO KNOW MORE

As we have told you previously in this Manual, the Aux Send 2 Control both on Mono and stereo channels is factory wired as POST-FADER. If you have some skill in electronic components soldering you can modify this setting and have all your AUX sends configured as PRE-FADER.

Aux

Aux

(PRE)

 

(PRE)

POST

Disconnect

POST

the POST route

Solder the PRE route

Before

After

Modification on mono and stereo channels

17

Image 18
Contents Channel Mixing Console Power Supply Safety Related SymbolsImportant Safety Instructions External ConnectionPreface Table of Contents Introduction Features Ready to START? Control Elements Channel Mixing ConsoleInput Level setting Mono MIC/LINE channelsLOW-CUT Filter Stereo Inputs Peak AUX SendsPAN LevelMaster Section Stereo AUX Return Track IN/OUT InputOutput AUX Send 1AC Inlet with Fuse Holder Rear Panel DescriptionPHANTOM4 Main MIX OutputInstallation and Connection Some Final Tips on Wiring Configuration Stereo TRS Jack PlugTapped Connection Direct Output Lead For the Experts WHO Want to Know More Modification on mono and stereo channelsSystem Block Diagrams Technical Specification Return Notice WarrantyWarranty Registration Card Terms and ConditionsSeikaku Technical Group Limited