Nilfisk-ALTO DJM-3 Channel Section PHONO-LINE to Line switch, Gain control, Equalizer control

Page 8
-. The MIC ON switch
-.TREBLE and BASS controls
3.1.2 The MIC INPUT Section -. LEVEL control

3.1.1 The CHANNEL Section

 

-. PHONO-LINE to LINE switch

1

This switch is available on both input channels. You shall use the LINE position for all high level audio signals such as CD Players, DAT, MD, etc. You shall use the PHONO- LINE position to connect the turntables making sure that the PHONO-LINE switch on the rear panel is on PHONO position. With this switch (the one on the rear panel) on LINE position, the Input Channel will accept a high level audio signal.

-. The GAIN control

2

Via this knob you will adjust the input level. Do not turn this control too much clockwise or you will overload the channel but do not turn it too much counterclockwise or you will generate background hiss.

-. The EQUALIZER control 3

Both Input Channels are provided with 3 bands equaliser:

Bass, Middle and Treble and you can adjust the gain range 5 of each from -30dB to +15dB.

-. The PROGRAM Fader

4

There is a Program Fader available on both channels. For optimum performance and operation the 2 Faders are VCA (Voltage Control Amplifier) controlled. These Faders adjust the overall level of the input channels.

-. The CURVE control

5

Both input channels include a 3-position switch denominated

CURVE.

If you set the CURVE switch on SHARP position the level will be changed quite quickly by the PROGRAM Fader even if you move the Fader slowly.

If you set the CURVE switch in SOFT position, the level will be changed much more slowly by the PROGRAM Fader even if you move the Fader quickly.

If you set the CURVE switch in MID position you will combine the SHARP and SOFT configuration.

6

You can adjust the level of the microphone signal via this control.

7

With the treble and bass control you can create sound effects and make the sounds of any microphone better. The gain range of both bass and treble controls is of -15dB to +15dB.

8

Push the MIC On button to activate the MIC INPUT channel.

1

2

3

4

6

7

8

6

Image 8
Contents DJM-3 Page Safety Related Symbols Important Safety InstructionsPower Supply External ConnectionPreface Table of Contents Introduction Control Elements 3.1 The TOP Cover Channel Section PHONO-LINE to Line switch Gain controlEqualizer control Program FaderSurround on switch Mode switchMAIN/PFL switch Main OUT Section Level controlBeat Assist switch Tempo DisplayTempo Difference Led segment Time Offset Led segmentMIC in Jack AC Inlet and Fuse Holder UK/AUSTTechnical Specifications InputsSystem Block Diagram Warranty Warranty Registration CardSeikaku Technical Group Limited