Multiquip MTR40SF Inspection, Prior to Operation, Main Spring and Crankcase Lubrication, Fuel

inspection

This section is intended to assist the operator with the inspection of the rammer. It is extremely important that this section be read carefully before attempting to operate the rammer.

„„DO NOT use your rammer until this section is thoroughly understood.

„„Check all nuts, bolts fasteners for tightness. Retighten as necessary.

„„Clean any dirt from the recoil starter and engine cooling fins. Wipe the entire rammer clean before operating.

„„Replace any missing or damaged Safety Operation decals. It is extremely important that this section be read carefully before attempting to operate the rammer. DO NOT use your rammer until this section is thoroughly understood.

Prior to Operation

1.When transporting the rammer, carry it by the grip handle located on the body (Figure 3).

Figure 3. Grip Handle

Main Spring and Crankcase Lubrication

1.There are 2 grease fittings (Figure 18) that require lubrication of the main springs. Lubricate these fittings as outlined in the maintenance section of this manual.

2.There are 2 grease fittings (Figure 19) that require lubrication of the crankcase. Lubricate these fittings as outlined in the maintenance section of this manual.to replenish it often (Figure 5).

Fuel

1.This rammer is equipped with a two-cycled gasoline engine. Use only unleaded gasoline. High test ethyl gasoline is not recommended.

2.If fuel is low, remove the fuel filler cap (Figure 4) and fill with onlyunleaded gasoline. Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel the rammer if the engine is hot or running.

Figure 4. Fuel Tank

Figure 4. Fuel Tank

Engine Oil Check

1.To check the engine oil level, place the rammer on secure level ground with the engine stopped.

2.Remove the filler cap/dipstick from the engine oil filler hole (Figure 5) and wipe it clean.

Figure 5. Engine Oil Dipstick

3.Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick.

page 14 — MTX40sf RAMMER • operation and parts manual — rev. #0 (11/28/12)