HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Post error messages, 10POST error messages

POST error messages

The Power-On Self Text (POST) is a series of diagnostic tests that runs automatically when the workstation is powered on.

Audible and visual messages occur before the operating system starts if the POST encounters a problem. POST checks the following items to ensure that the workstation system is functioning properly:

●Keyboard

●DIMMs

●Diskette drives

●All mass storage devices

●CPUs

●Controllers

●Fans

●Temperature sensors

●Cables (front/rear panels, audio, and USB ports)

The table shown next describes the POST error messages.

Table 6-10POST error messages

Screen message	Probable cause	Recommended action
101—Option ROM Checksum	System ROM checksum.	Verify the correct ROM:
Error		1.	Flash the ROM, if needed.
		2.	If an expansion card was recently added, remove
			it to find out if the problem remains.
		3.	Clear CMOS. If the message disappears, there
			might be a problem with the expansion card
		4.	Replace the system board.
102—System Board Failure	DMA, timers, and so forth, might be set	1.	Clear the CMOS.
	improperly or might be defective.	2.	Remove the expansion boards.
		3.	Replace the system board.
110—Out of memory space for	Option ROM for a device could not run	Run the Computer Setup (F10) Utility to disable
option ROMs	because of memory constraints.	unneeded option ROMs, and to enable ACP0/USB
		Buffers at Top of Memory.

162—Systems Options Error

163—Time and Date Not Set ● Invalid time or date in configuration memory.

● RTC battery might need replacement.

● CMOS jumper might not be properly installed.

1.Set the date and time from the Control Panel or in the Computer Setup (F10) Utility (depending on the operating system).

2.If the problem persists, replace the RTC battery.

196 Chapter 6 Diagnostics and troubleshooting ENWW