HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Enww

5.Lift and hold the drive release latch at the green touch point while sliding the slot load carrier into the bay. When the front of the carrier is near its final position, release the latch, but continue to slide the carrier inward until the latch closes and engages the carrier 2.

NOTE: Install the slot load optical bay with the slot load drive at the top.

Figure 5-54Installing the slot load assembly in the chassis

6.Connect the chassis power cable to the hard drive power connector as shown in the following figure.

TIP: Place excess cabling in the slot load bay.

Figure 5-55Connecting chassis power cable to hard drive connector

116 Chapter 5 Replacing components ENWW