HP Z800 Sp632up SP632UPABA Power switch cable assembly, Removing the power switch cable assembly

Power switch cable assembly

This section describes how to remove and install the power switch cable assembly.

Removing the power switch cable assembly

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the expansion card support (see Removing the expansion card support on page 77).

4.Remove the expansion card guide/front fan holder (see Removing the expansion card guide/front fan holder on page 126).

5.Remove the right side panel (see Removing the right side panel on page 80).

6.Remove the front bezel (see Removing the front bezel on page 85).

7.Disconnect the speaker (see Removing the speaker on page 81).

8.Cut the cable ties , and then move the power switch cable assembly screw 2 as shown in the following figure.

Figure 5-20Loosening the power switch cable assembly

9.Remove the cable assembly by pulling cables through the lower right chassis wall opening and the front chassis wall opening.

90 Chapter 5 Replacing components ENWW