HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Installing a hard disk drive

Installing a hard disk drive

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Select the proper drive bay (SATA or SAS) in which to install the drive. Use the hard disk drive installation order shown in the following figure.

Figure 5-41Selecting a drive bay

4.If there is a drive carrier in the drive slot, press the hard drive carrier release latch at the green touch point and rotate the handle outward . Pull the drive carrier out of the hard drive bay as shown in the following figure 2.

Figure 5-42Removing the drive carrier from the chassis

108 Chapter 5 Replacing components ENWW