HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Removing a Dimm

Removing a DIMM

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

CAUTION: To ensure that DIMMs are not damaged during removal or installation, power off the workstation and unplug the power cord from the AC power outlet. If you do not unplug the power cord before installing memory, the modules might be damaged and the workstation will not recognize the memory changes.

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (Removing the airflow guide on page 76).

4.Remove the memory fans (see Removing the memory fans on page 136).

5.Carefully push outward on the memory slot socket levers . Lift the DIMM straight up and out of its socket 2 as shown in the following figure.

Store the DIMM in an anti-static bag. Figure 5-88Removing a DIMM

140 Chapter 5 Replacing components ENWW